Cisco Cisco OptoStar II Driver Amplifier Guide De Montage
Operating using Console Software
This section introduces the procedures to use the OptoStar II console to manage
the OptoStar II intelligent communications interface module.
the OptoStar II intelligent communications interface module.
Before You Begin
•
One PC
•
Mini-USB data cable
•
OptoStar II console software installation package
System Requirements
•
Supported operation system: Windows 7, Windows Vista, Windows Server
2003, and Windows XP
2003, and Windows XP
•
Processor: 400 MHz Pentium or equivalent processor (minimum requirement);
1 GHz Pentium or equivalent processor (recommended)
1 GHz Pentium or equivalent processor (recommended)
•
Memory: 96 MB (minimum requirement); 256 MB (recommended)
•
Hard drive: 500 MB free space
•
Monitor: 800 x 600, 256-color (minimum requirement); 1024 x 768 high color,
32-bit (recommended)
32-bit (recommended)
Start
1. Make sure that the fiber and RF cables of relevant modules of the OptoStar II
platform are connected.
2. Turn the front panel switch of the OptoStar II power supply module to ON
position. The power supply module and other modules will initialize for
about 5 seconds, and the ICIM will load for about 25 seconds.
about 5 seconds, and the ICIM will load for about 25 seconds.
Note: The system will achieve optimal working condition after one hour’s
warm-up.
warm-up.
Continued on next page
OL-29660-03
Operation
3-13