Cisco Cisco OptoStar II 1550nm Transmitter Guide De Montage
Operating using NMS Software, Continued
The table below lists the basic parameters of the OptoStar II RF switch module.
Basic Parameter
Description
Module Basic Information
Module Node Location
Module Node Location
Shows the IP of the node where the module
is located
S/N
Shows module serial number
Slot ID
Shows the ID of the slot where the module
is placed
Module Firmware Version
Shows module firmware version
Module Temperature
Shows the current module temperature (°C)
RF Input Information
RF Input Status in Channel A/B Shows channel A/B RF input status
RF Input Status in Channel A/B Shows channel A/B RF input status
Setup Parameters
The table below lists the setup parameters settings of the OptoStar II RF switch
module.
module.
Setup Parameters
Description
Factory Default
RF Input Information
Switch Mode
Switch Mode
Selection
Shows/sets auto/manual
switching mode
Auto switching mode
Channel A/B
Selection
Shows/sets channel A/B
Channel A
Comment
Comment
You may add applicable
comments as required.
None
3-26
Operation
OL-29669-02