Cisco Headend System Release 2.7 Mode D'Emploi
2
736123 Rev B
Overview
Scope
This guide applies to sites using SR 4.0 with PowerKEY® M-Card modules that
support M-Card software release 1.0 and later. The procedures in this guide
should not be used for SR 4.2 and later releases.
Note: The procedures in this guide can also be used with the lab release of
Note: The procedures in this guide can also be used with the lab release of
PowerKEY Single-Stream CableCARD (S-Card) software version 1.53.
Audience
This guide is written for DBDS operators and engineers, DNCS operators and
engineers, field engineers, and Cisco Services engineers who service CableCARD
hosts used in SR 4.0 systems. This guide assumes that users performing the
procedures in this guide are proficient in using basic UNIX commands, ftp, and a
hex editor.
Related Publications
You may find the following publications useful as resources when you implement
the procedures in this document.
Best Practices for Using Multi-Stream CableCARD Modules (part number
4005658)
Multi-Stream CableCARD 1.1 Software Release Notes (part number 4011042)
Setting Up the PowerKEY
®
CableCARD™ and M-Card™ Modules on the DNCS For
System Releases 2.5/3.5 and 4.0 (part number 4011765)
Document Version
This is the second release of this document.