Cisco Cisco Content Security Management Appliance M1070 Guide De Montage
5
5
Install the Appliance in a Rack
Install the Cisco M690 Content Security Management
Appliance following the instructions in the Cisco x90 Series
Content Security Appliances Installation and Maintenance
Guide.
Appliance following the instructions in the Cisco x90 Series
Content Security Appliances Installation and Maintenance
Guide.
Appliance Placement
•
Ambient Temperature—To prevent the appliance from
overheating, do not operate it in an area that exceeds an
ambient temperature of 104°F (40°C).
overheating, do not operate it in an area that exceeds an
ambient temperature of 104°F (40°C).
•
Air Flow—Be sure that there is adequate air flow around
the appliance.
the appliance.
•
Mechanical Loading—Be sure that the appliance is level
and stable to avoid any hazardous conditions.
and stable to avoid any hazardous conditions.
6
Temporarily Change Your IP
Address for Remote Access
To remotely configure the Cisco M690 using the network
connection, you must temporarily change the IP address of your
computer. Alternatively, you can use the serial console to
configure the Cisco M690, without changing the IP address. If
you use the serial console, proceed to section
connection, you must temporarily change the IP address of your
computer. Alternatively, you can use the serial console to
configure the Cisco M690, without changing the IP address. If
you use the serial console, proceed to section
below.
Note
Make a note of your current IP configuration settings
as you will need to revert to these settings after you
finish the configuration.
as you will need to revert to these settings after you
finish the configuration.
For Windows
The exact steps depend on your operating system version.
Step 1
Go to the Start menu and choose Control Panel.
Step 2
Click Network and Internet, then Network and Sharing
Center.
Center.
M690_QSG.fm Page 5 Thursday, March 31, 2016 5:43 PM