Cisco Cisco 1700 2600 3600 3700 Series VPN Module Livre blanc
© 2012 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information.
Page 48 of 55
no ip address
switch virtual link 2
mls qos trust cos
end
vss#conf t
Enter configuration commands, one per line. End with CNTL/Z.
vss(config)#int po2
vss(config-if)#no mls qos trust cos
HWIF-QOS: QoS configs are not allowed on VSL Portgroup
vss(config-if)#mls qos trust dscp
HWIF-QOS: QoS configs are not allowed on VSL Portgroup
The following output shows that for a member port of the VSL, the relevant CoS-queue mappings have already
been provisioned for both ingress and egress queues, even without QoS globally enabled:
vss#sh queueing int te2/5/4
Interface TenGigabitEthernet2/5/4 queueing strategy: Weighted Round-Robin
Port QoS is enabled
Trust state: trust COS
Extend trust state: not trusted [COS = 0]
Default COS is 0
Queueing Mode In Tx direction: mode-cos
Transmit queues [type = 1p3q4t]:
Queue Id Scheduling Num of thresholds
-----------------------------------------
01 WRR 04
02 WRR 04
03 WRR 04
04 Priority 01
WRR bandwidth ratios: 100[queue 1] 150[queue 2] 200[queue 3]
queue-limit ratios: 50[queue 1] 20[queue 2] 15[queue 3] 15[Pri Queue]
queue tail-drop-thresholds
--------------------------
1 70[1] 100[2] 100[3] 100[4]
2 70[1] 100[2] 100[3] 100[4]
3 100[1] 100[2] 100[3] 100[4]
queue random-detect-min-thresholds
----------------------------------
1 40[1] 70[2] 70[3] 70[4]
2 40[1] 70[2] 70[3] 70[4]
3 70[1] 70[2] 70[3] 70[4]
queue random-detect-max-thresholds
----------------------------------
1 70[1] 100[2] 100[3] 100[4]
2 70[1] 100[2] 100[3] 100[4]