Cisco Cisco Content Security Management Appliance M1070 Mode D'Emploi

Submit and commit your changes.

You can configure the default gateway via the GUI through the Management Appliance > Network > 
Routing page (see 

) or via the 

setgateway

 command 

in the CLI.

SSL v3 is not secure and you should not use it. 

You can choose the communication protocol to be used for each of the following:

Updater server 

End-user access to the spam quarantine

Web-based administrative interface to the appliance 

LDAPS 

To view the currently selected protocols and available options, or to change protocols, use the 

sslconfig

 command in the command-line interface. 

Cisco update servers do not support SSL v3. 

If you are using a local (remote) update server, and for all other services and web browsers, the 
protocol you choose must be supported by and enabled on the server and tools you are using. 

One of the available options must be enabled for each service you use. 

Changes made using the 

sslconfig

 command require a Commit.

Affected services will be briefly interrupted after you commit changes made using the 

sslconfig

 

command. 

When gathering data for reports, the Security Management appliance applies the time stamp from the 
information that was set when you configured the time settings on the Security Management appliance. 
For information, see 

To set time-related settings using the command-line interface, use the 

ntpconfig

, 

settime

, and 

settz

 

commands.