Cisco Cisco Content Security Management Appliance M1070 Mode D'Emploi
2-8
Cisco IronPort AsyncOS 8.0 for Security Management User Guide
Chapter 2 Setup, Installation, and Basic Configuration
•
Use the Options menu at the top right side of the GUI window to select the language for the session.
(The method that works depends on the method used to authenticate your login credentials.)
Running the System Setup Wizard
AsyncOS provides a browser-based System Setup Wizard to guide you through the process of system
configuration. Later, you may want to take advantage of custom configuration options not available in
the wizard. However, you must use the wizard for the initial setup to ensure a complete configuration.
configuration. Later, you may want to take advantage of custom configuration options not available in
the wizard. However, you must use the wizard for the initial setup to ensure a complete configuration.
The Security Management appliance supports this wizard via the GUI only. It does not support system
setup through the command line interface (CLI).
setup through the command line interface (CLI).
Before You Begin
Complete all tasks in the
.
Warning
The System Setup Wizard completely reconfigures the appliance. Only use the wizard when you
initially install the appliance, or if you want to completely overwrite the existing configuration.
initially install the appliance, or if you want to completely overwrite the existing configuration.
Be sure to connect the Security Management appliance to your network through the Management port.
Warning
The Security Management appliance ships with a default IP address of
192.168.42.42
on the
Management port. Before connecting the Security Management appliance to your network, ensure
that no other device’s IP address conflicts with the factory default setting.
that no other device’s IP address conflicts with the factory default setting.
Note
By default, your session times out if you are idle for more than 30 minutes or if you close the browser
without logging out. If the session times out while you are running the System Setup Wizard, you need
to start over from the beginning.
without logging out. If the session times out while you are running the System Setup Wizard, you need
to start over from the beginning.
To change the session timeout limit, see
To change the session timeout limit, see
Note
By default, your session times out if you are idle for more than 30 minutes or if you close the browser
without logging out. If this happens, you must reenter your user name and password. If the session times
out while you are running the System Setup Wizard, you need to start over from the beginning. To change
the timeout limit, see
without logging out. If this happens, you must reenter your user name and password. If the session times
out while you are running the System Setup Wizard, you need to start over from the beginning. To change
the timeout limit, see
.
Overview of the System Setup Wizard
Procedure
Step 1
Reviewing the end user license agreement
Step 2
Configuring the following system settings:
•
Notification settings and AutoSupport