Cisco Cisco Content Security Management Appliance M1070 Mode D'Emploi

Verify that you have connected the Security Management appliance to your network through the 
Management port.

Enter the fully qualified hostname for the Security Management appliance. This name should be 
assigned by the network administrator.

Enter the IP address of the Security Management appliance.

Enter the network mask and IP address of the default router (gateway) on your network.

Next, configure the Domain Name Service (DNS) settings. AsyncOS contains a high-performance 
internal DNS resolver/cache that can query the Internet’s root servers directly, or the system can use 
DNS servers that you specify. If you use your own servers, you need to supply the IP address of each 
DNS server. You can enter up to four DNS servers when you are using the System Setup Wizard.

The DNS servers you specify have an initial priority of 0. For more information, see the 

.

The appliance requires access to a working DNS server to perform DNS lookups for incoming 
connections. If you cannot specify a working DNS server that is reachable by the appliance while you 
are setting up the appliance, you can select Use Internet Root DNS Servers, or else temporarily specify 
the IP address of the Management interface so that you can complete the System Setup Wizard.

Now, the System Setup Wizard displays a summary of the setup information that you have entered. If 
you need to make any changes, click Previous at the bottom of the page and edit the information.