Cisco Cisco Content Security Management Appliance M1070 Mode D'Emploi

The Management Appliance > Network > IP Interfaces page (and 

interfaceconfig

 command) enables 

you to add, edit, or delete IP interfaces.

You cannot change the name or Ethernet port associated with the Management interface on the Security 
Management appliance. Further, the Security Management appliance does not support all of the features 
discussed below (Virtual Gateways, for example).

The following information is required when you configure an IP interface:

If you have completed the System Setup Wizard as described in 

 and committed the changes, the Management interface should already be 

configured on the appliance.

The nickname of the interface. 

IP addresses within the same subnet cannot be configured on separate physical 
Ethernet interfaces. 

You can enter the netmask in standard dotted octet form (for example, 
255.255.255.0) or hexadecimal form (for example, 0xffffff00). The default 
netmask is 255.255.255.0, a common class C value. 

AsyncOS automatically calculates the default broadcast address from the IP 
address and the netmask. 

The hostname that is related to the interface. This hostname is used to identify the 
server during the SMTP conversation. You are responsible for entering a valid 
hostname associated with each IP address. The software does not check that DNS 
correctly resolves the hostname to the matching IP address, or that reverse DNS 
resolves to the given hostname. 

FTP, SSH, Telnet, Cisco IronPort Spam Quarantine, HTTP, and HTTPS can be 
enabled or disabled on the interface. You can configure the port for each service. 
You can also specify the HTTP/HTTPS, port, and URL for the Cisco IronPort 
Spam Quarantine.