Cisco Cisco Prisma II EDR Receiver Guide De Montage
2-4
Installation
78-748704-01 Rev C
Site Requirements,
Continued
Electrical Power
The Prisma II modules receive electrical power from the Prisma II Chassis via the
Prisma II power supplies. For specific information concerning chassis power
requirements and power supply installation, see the guide that was shipped with the
chassis, the Prisma II Chassis Installation and Operation Guide, part number 713375.
Chassis Slot Availability
The Prisma II bdr 2:1 Dual Receive Processor is a double-wide module. It may only
be installed in slots 5 through 16. Slots 15 and 16 are usually reserved for the
Intelligent Communications Interface Module (ICIM), if installed. However, if an
ICIM is not installed in slots 15 and 16, this processor or any other module(s) could
be installed in those slots.
Power Supply Installation Slot Restrictions (Slots 1 through 4 )
Important: Slots 1 through 4 of the chassis are reserved exclusively for the Prisma II
primary and redundant power supplies. If a redundant power supply is not
installed, this module must not be installed in the redundant power supply slots.
If only one power supply is installed, a Prisma II Power Supply Blank, part number
If only one power supply is installed, a Prisma II Power Supply Blank, part number
716308, must be installed in the unused power supply slots.
Front and Rear Access Chassis Styles
The chassis has power inlets, RF input and output ports, and other connectors that
are located on the connector interface panel. This panel may be located on the front
(front access) or rear (rear access) of the chassis, depending on the system you have
purchased. Regardless of their location, these connections are labeled the same,
serve the same function, and are made in the same manner.
For more detailed information concerning the connector interface panel, see the
For more detailed information concerning the connector interface panel, see the
guide that was shipped with the chassis, the Prisma II Chassis Installation and
Operation Guide, part number 713375.