Cisco Cisco TelePresence MX700 Note De Mise
Known limitations
Cisco TelePresence System C-Series Software Release Notes
Page 122 of 133
75045
TC2.x.x and above
When setting the H.323 id to
"number.something@domain", the endpoint
becomes unreachable. The workaround is to
not let H.323 ID start with a number.
not let H.323 ID start with a number.
TC3.0.0 and above
The Cisco TelePresence System codec
C40/C60 (rev. 1), will not provide proper
analogue VGA output for any resolution of 1080
lines or more.
Any
The Cisco TelePresence System codec C40
will reduce its capability set when using internal
will reduce its capability set when using internal
MultiSite. When this is done, the main stream
will maximum be able to transmit w576p until all
calls are disconnected.
Any
The Cisco TelePresence System codec C60
will reduce its capability set when using internal
MultiSite. When this is done, the dual stream
MultiSite. When this is done, the dual stream
will maximum be able to transmit WXGA until all
calls are disconnected.
84627
Any
The Cisco TelePresence System EX60/90 does
not support usage of the remote control. The
Cisco TelePresence Touch Screen
must be
used to control these devices.
78636
TC4
A search in the local phonebook will list all
contacts including those in the subfolders.
83992
TC4
To use SIP verified, a CA list must be uploaded
to the /user folder using SCP (root user must be
to the /user folder using SCP (root user must be
enabled). The CA list must be named
‘sipcalist.pem’ and be in DER format.
Polycom
Reference ID
Equipment
Summary
Polycom MGC
9.0.3.1
60 frames per second was disabled during the
testing (Advanced
Configuration/Video/Input/Source/Optimal
Definition/Threshold60fps = Never).
MGC conference is set to continuous presence,
MGC conference is set to continuous presence,
AES and H.239:
Far End Camera Control is not working.
Far End Camera Control is not working.
Call rates down to 256kbps works fine. 256kbps
and lower will experience loss of video.
MGC conference set to voice switched, AES
MGC conference set to voice switched, AES
and H.239:
Following conference rates does not work:
Following conference rates does not work:
1.1Mbps
MGC conference is set to continuous presence,
MGC conference is set to continuous presence,
no AES and H.239:
H.239 does not work very well with the MGC. A
H.239 does not work very well with the MGC. A
lot of issues was seen when testing H.239.
64418
C Series
Ver. TC2.1.0
(No Video
Polycom VSX Ver. 9.0.5)
Currently if the video source 1 (PrecisionHD
1080p camera) is set to sharpness then the
Polycom VSX will not display video as the
TANDBERG codec will transmit w448p, which
TANDBERG codec will transmit w448p, which
is not supported by the VSX. Workaround: Set
PrecisionHD 1080p camera to motion.