Cisco Cisco Email Security Appliance C160 Références techniques

36

I R O N P O R T   A S Y N C O S   7 . 1   C L I   R E F E R E N C E   G U I D E

In this example, a new configuration file is pasted directly at the command line. (Remember 
to type Control-D on a blank line to end the paste command.) Then, the system setup wizard 
is used to change the default hostname, IP address, and default gateway information. Finally, 
the changes are committed. 

Description

To test the IronPort AsyncOS configuration, you can use the 

mailconfig

 command 

immediately to send a test email containing the system configuration data you just created 
with the 

systemsetup

 command.

Usage

Commit: This command does not require a ‘commit’.

Cluster Management: This command can be used in all three machine modes (cluster, group, 
machine).

Batch Command: This command does not support a batch format

Code Example 3-15 

loadconfig

 - Example 2

mail3.example.com> loadconfig

1. Paste via CLI

2. Load from file

[1]> 1

Paste the configuration file now.

Press CTRL-D on a blank line when done.

[The configuration file is pasted until the end tag </config>. Control-D is entered on a separate 
line.] 

Values have been loaded.

Be sure to run "commit" to make these settings active.

mail3.example.com> systemsetup

mail3.example.com> commit

Please enter some comments describing your changes:

[]> pasted new configuration file and changed default settings via