Cisco Cisco FirePOWER Appliance 7020
D-33
FireSIGHT System User Guide
Appendix D Command Line Reference
Configuration Commands
ipv6 manual
Manually configures the IPv6 configuration of the device’s management interface.
Syntax
configure network ipv6 manual ip6addr/ip6prefix [ip6gw]
where
ip6addr/ip6prefix
is the IP address and prefix length and ip6
gw
is the IPv6 address of the default
gateway.
Example
> configure network ipv6 manual 2001:DB8:3ffe:1900:4545:3:200:f8ff:fe21:67cf 64
management-port
Sets the value of the device’s TCP management port.
Syntax
configure network management-port number
where
number
is the management port value you want to configure.
Example
> configure network management-port 8500
password
Allows the current user to change their password. After issuing the command, the CLI prompts the user
for their current (or old) password, then prompts the user to enter the new password twice.
for their current (or old) password, then prompts the user to enter the new password twice.
Access
Basic
Syntax
configure password
Example
> configure password
Enter current password:
Enter new password:
Confirm new password:
stacking disable
On managed devices, removes any stacking configuration present on that device: on devices configured
as primary, the stack is removed entirely; on devices configured as secondary, that device is removed
from the stack. This command is not available on virtual devices or ASA FirePOWER devices and you
cannot use it to break a clustered stack.
as primary, the stack is removed entirely; on devices configured as secondary, that device is removed
from the stack. This command is not available on virtual devices or ASA FirePOWER devices and you
cannot use it to break a clustered stack.