Brother RJ-4030Ai Guide De Référence

Page de 48
Raster Command Reference 
 
 
- 22 - 
4. Printing Command Details 
(6) Phase type and phase number 
If the phase number is not used, both are fixed at 00h. 
Phase State 
Phase Type 
Receiving state 
00h 
Printing state 
01h 
 
Receiving state 
Phase 
Value (Dec.) 
Higher Order Bytes 
Lower Order Bytes 
Waiting to receive 
00h 
00h 
 
Printing state 
Phase 
Value (Dec.) 
Higher Order Bytes 
Lower Order Bytes 
Printing   
00h 
00h 
  When the printer is turned on, it is in the receiving state. When printing begins, it changes to the 
“printing” 
phase (phase type: printing state; phase number: printing), and the printer sends that phase status to the 
computer.  When  printing  has  finished,  the  printer  sends  the  “receiving  state”  phase  status  (phase  type: 
receiving state; phase number: waiting to receive) to the computer. Unless an error occurs during printing, 
the printer sends the “printing completed” status. 
  With concurrent printing, printing starts even if a print command has  not been sent from the computer in 
order to print at high speed. At this time, care should be taken since the 
“printing” and “waiting to receive” 
phase statuses will be sent. (
Refer to 
.)   
(7) Notification number 
Notification 
Value 
Not available 
00h 
Cooling (started) 
01h 
Cooling (finished) 
02h 
 
(8) Battery level 
Battery Level 
Value 
Full 
00h 
Half 
01h 
Low 
02h 
Charging required 
03h 
AC adaptor in use 
04h