Samsung RS757LHQESR Manuel D’Utilisation

Page de 140
safety information 
_03
 
- If the appliance contains isobutane refrigerant 
(R-600a), a natural gas with high environmental 
compatibility that is, however, also combustible. 
When transporting and installing the appliance, 
care should be taken to ensure that no parts of 
the refrigerating circuit are damaged.
SEVERE WARNING SIGNS FOR 
INSTALLATION
•  Do not install this appliance near a 
heater, inflammable material.
•  Do not install this appliance in a humid, oily or 
dusty location, in a location exposed to direct 
sunlight and water (rain drops).
 
- Deteriorated insulation of electrical parts may 
cause an electric shock or fire.
•  Do not place this refrigerator in direct sunlight or 
expose to the heat from stoves, room heaters 
or other appliances.
•  Do not plug several appliances into the same 
multiple power board. 
The refrigerator should always be plugged into 
its own individual electrical outlet which has a 
voltage rating that matched the rating plate.
 
- This provides the best performance and 
also prevents overloading house wiring 
circuits, which could cause a fire hazard from 
overheated wires. If the wall socket is loose, do 
not insert the power plug.
 
- There is a risk of electric shock or fire.
•  Do not use a cord that shows cracks or 
abrasion damage along its length or at either 
end.
•  Do not bend the power cord excessively or 
place heavy articles on it.
•  Do not use aerosols near the refrigerator.
 
- Aerosols used near the refrigerator may cause 
an explosion or fire.
•  Do not install this appliance in a location where 
gas may leak.
 
- This may result in an electric shock or fire.
•  The installation or any service of this 
appliance is recommended by a qualified 
technician or service company.
 
- Failing to do so may result in an electric shock, 
fire, explosion, problems with the product, or 
injury.
•  This refrigerator must be properly installed and 
located in accordance with the manual before it 
is used.
•  Connect the power plug in proper position with 
WARNING
the cord hanging down.
 
- If you connect the power plug upside down, 
wire can get cut off and a cause fire or an 
electric shock.
•  Make sure that the power plug is not squashed 
or damaged by the back of the refrigerator.
•  When moving the refrigerator, be careful not to 
roll over or damage the power cord.
 
- This constitutes a fire hazard.
•  The appliance must be positioned so that the 
plug is accessible after installation.
•  The refrigerator must be grounded.
 
- You must ground the refrigerator to 
prevent any power leakages or electric 
shocks caused by current leakage from 
the refrigerator.
•  Never use gas pipes, telephone lines or other 
potential lightening rods as ground.
 
- Improper use of the ground plug can result in 
an electric shock.
•  If the power cord is damaged, 
have it replaced immediately by the 
manufacturer or its service agent.
•  The fuse on the refrigerator must be changed 
by a qualified technician or service company.
 
- Failing to do so may result in an electric shock 
or personal injury.
•  Never stare directly at the UV LED lamp for long 
periods of time.
 
- This may result in eye strain due to the 
ultraviolet rays.
CAUTION SIGNS FOR 
INSTALLATION
•  Keep ventilation opening in the appliance 
enclosure or mounting structure clear of 
obstruction.
•  The new hose-sets supplied with the appliance 
are to be used and that old hose-sets should 
not be reused.
SEVERE WARNING SIGNS FOR 
USING
•  Do not insert the power plug with wet 
hands.
•  Do not store articles on the top of the appliance.
 
- When you open or close the door, the articles 
may fall and cause a personal injury and/or 
CAUTION
WARNING
DA68-01312L-02.indb   3
2016. 11. 19.   �� 9:53