Samsung RF67DERS Manuel D’Utilisation

 

setting up

 

setting up

SETTING Up ThE REFRIGERATOR

Now that you have your new Refrigerator installed in place, you are ready to set up and enjoy the features 
and functions of the appliance. By completing the following steps, your Refrigerator should be fully 
operational.

1.  Place the Refrigerator in an appropriate location with reasonable clearance between the wall and 

the Refrigerator. Refer to installation instructions in this manual. (P8. Selecting the best location for 
the Refrigerator)

2.  Once the Refrigerator is plugged in, make sure the interior light comes on when you open the 

doors.

3.  Set the Temperature control to the coldest temperature and wait for an hour. The Freezer will get 

slightly chilled and the motor will run smoothly.

4.  After powering the Refrigerator, it will take a few hours to reach the appropriate temperature. You 

can store food and drinks in the Refrigerator after the temperature is sufficiently cool.

REMOvING ThE REFRIGERATOR dOORS

Some installations require door/drawer removal to transport the Refrigerator to its final location.
Do not remove the door/drawer if it is not needed. Before removing the door/drawer make sure you read 
following items.

Disconnect power to the Refrigerator before removing the door or drawer.

•  Be careful not to drop, damage or scratch the door/drawer while removing them.
•  Be careful not to get injured while removing the door/drawer.
•  Reattach the door/drawer properly to avoid:

-  Moisture from air leakage.
-  Uneven door alignment.
-  Wasting energy due to improper door seal.

Phillips Head Driver(+)

Flat Head Driver(-)

Socket Wrench 

(10mm) (for bolts)

Hex Wrench (Ø5mm)

(for Mid hinge)

Hex wrench 

(5/32 inch)

(for Mid hinge shaft)

WARNING

DA68-01868P.indb   14

2010.6.29   2:30:3 PM