Samsung FSR2 Manuel D’Utilisation

English - 31

O

PERA

TING

To save electricity, the Panel Display turns off

automatically under the following conditions: When

no button has been pressed, when no doors

are open, or when no Dispenser Lever has been

pushed.

However, the icon indicating your cubed or

crushed ice selection, will stay on.

When you press a button, open a door, or push

a Dispenser Lever, the Panel Display will turn on

again.

Except for the Water, and Cubed / Crushed

Ice buttons, all function buttons will become

operational after you remove your finger from the

button you are currently pressing.

Water
The indicator is supposed to turn on at all

times as it indicates that the water can be

dispensed properly.

Cubed Ice
Crushed Ice
Press the Cubed Ice or Crushed Ice

button to select the type of ice you want

dispensed.

Each time you press the button, the cubed

and crushed ice modes alternate and

the Cubed or Crushed ice icon lights up,

indicating your selection.

If you don’t need ice, turn the function off

to save on water and energy consumption

(See Ice Maker Off below).

Water filter usage
This icon lights up when you need

to change the filter, usually after the

refrigerator has dispensed about 300

gallons of water (after about 6 months).

The icon will blink red for several seconds

when you open or close the door.

After you install the new water filter, reset

the filter indicator by touching and holding

the Hold 3 sec for Filter Reset button for

3 seconds.

- If water is not dispensing or dispensing

slowly, you need to replace the water

filter because the water filter is clogged.

- Some areas have large amounts of lime

in their water, which causes the water

filter to clog more quickly.

This icon lights up when you activate the

Lock function.

When the Control Lock icon is lit, all the

panel buttons, including the Ice button

and the dispensers, are locked and de-

activated.

Press and hold the Ice Maker Off/Control

Lock button for 3 seconds to turn Control

Lock off and re-activate the panel buttons.

Touching this button turns the door open

alarm on and off.

If the door alarm is set to On, an alarm

beeps if any refrigerator door is left open

for more than two minutes.

The beeping stops when you close the

door.

The door alarm function is pre-set to On in

the factory.

You can turn it off by pressing and then

releasing the Alarm button.

You can turn it back on in the same

fashion.

The icon lights up when the function is on.

When the Door Alarm function is on and

the alarm sound is triggered, the Door

Alarm Icon will blink while the alarm

sounds.

DA68-02976N-03.indb   31

2016. 10. 6.   �� 5:08