Samsung RSH5PTPN Manuel D’Utilisation

Page de 192
setting up
 
_15
01 SETTING UP
Connect the water line to the 
refrigerator.
-  Remove the compressor cover of the refrigerator.
-   Connect the water line to the valve, as shown in 
the fi gure.
-  When connected, check if there is any leakage.
    If any, repeat the connection.
-  Reattach the compressor cover of the refrigerator.
Secure the water line.
-   Using clip ”A”, fi x the water 
line to the wall (the back of 
refrigerator).
-    When the water line is 
secure, make sure whether 
the water line is not 
excessively bent, pinched or 
squashed.
Removing any residual matter inside 
the water supply line after installing 
fi lter.
1.     Turn ON the main water supply & turn OFF the 
valve to the  water supply line.
2.    Run water through the dispenser until the water 
runs clear (approx. 1L). This will clean the water 
supply system and remove air from the lines.
3.     Additional fl ushing may be required in some 
households.
4.    Open the refrigerator door and make sure there 
are no water leaks coming from the water fi lter.
A newly installed water fi lter cartridge may cause 
water to briefl y spurt from the water dispenser. 
This is due to air getting into the line. It should 
pose no problem to operation.
Check the amount of water supplied 
to the ice tray.
1. Lift up the icemaker cover and gently pull out.
2.  When you press the Test button for 3 seconds, 
the ice cube container is fi lled with water from the 
water supply tap. Check to make sure the amount 
of water is correct (see the illustration below).
     If the water level is too low, the ice cubes will be 
small. This is a water pressure problem from with 
in the main water pipes, not the refrigerator.
WATER LINE
INSTRUCTIONS
COMPRESSOR COVER OF
REFRIGERATOR
CONNECTION NUT
CLIP A
WATER LINE
Ice maker
1
Feeler Arm
2
Test button
Check the water level
DA99-02318R(0.3).indb   Sec4:15
DA99-02318R(0.3).indb   Sec4:15
2012.10.6   12:25:34 PM
2012.10.6   12:25:34 PM