Samsung RS30GKASLA Manuel D’Utilisation

Page de 60
10_
 
setting up
When the door of the freezer is higher 
than the fridge
Insert a fl at-blade screwdriver into a slot on the 
fridge leg, then turn it clockwise.
CHECKING THE WATER 
DISPENSER LINE
A water dispenser is one of the helpful features on 
your new Samsung Refrigerator. To help promote 
better health, the Samsung water fi lter removes 
unwanted particles from your water. However, it 
does not sterilize or destroy microorganisms. You 
may need to purchase a water purifying system to 
do that.
In order for the ice maker to operate properly, a 
water pressure of 20~125 psi (pound per square 
inch) is required. Under normal conditions, a 170 cc 
(5.75 oz.) paper cup can be fi lled in 10 seconds.
If the Refrigerator is installed in an area with low 
water pressure (below 20psi), you can install a 
booster pump to compensate for the low pressure.
Make sure the water storage tank inside the 
Refrigerator is properly fi lled. To do this, press the 
water dispenser lever until the water runs from the 
water outlet.
Water line installation kits are available at extra 
cost from your dealer. We recommend using a 
water supply kit that contains copper tubing.
The new hose-sets supplied with the 
appliance are to be used and that old hose-
sets should not be reused.
Check the accessory list below.
Water line fixer and 
screws
Pipe connector
Water line
Clip
When the Freezer part is lower than 
the Fridge part.
Insert a fl at-blade screwdriver into a slot on the 
Freezer Leg, then turn it clockwise.
When the Fridge part is lower than 
the Freezer part.
Insert a fl at-blade screwdriver into a slot on the 
Fridge Leg, then turn it clockwise.
Refer to the next section for the best way to 
make very minor adjustments to the doors.
MAKING MINOR ADJUSTMENTS 
TO THE DOORS
Remember, a level refrigerator is necessary for 
getting the doors perfectly even. If you need 
help, review the previous section on levelling the 
refrigerator.
When the door of the fridge is higher 
than the freezer
Insert a fl at-blade screwdriver into a slot on the 
freezer leg, then turn it clockwise.
Screwdriver(-)
Screwdriver(-)
Freezer Leg
Freezer Leg
Screwdriver(-)
Screwdriver(-)
Fridge Leg
Fridge Leg