Samsung RR92WERS Manuel D’Utilisation

setting up

 

_7

01 SETTING UP

REVERSING THE 
REFRIGERATOR DOOR

 Samsung recommends that reversing of 
the door opening is only completed by 
Samsung approved Service providers. 
This will be on a chargeable basis and at 
the customers expense.

   Any damage caused while attempting to 
reverse the door opening is not covered under 
the appliance manufactures warranty.
Any repairs requested due to this circumstance 
will be completed on a chargeable basis at the 
customers expense.

Required Tools (Not provided)

Phillips Head 

Driver (+)

Flat Head 

Driver (-)

10 mm Socket 

Wrench 

(for bolts)

8 mm 

Socket Wrench 

(for bolts)

Spanner

(for hinge shaft)

4 mm Hex 

Wrench

(for bottom 

hinge shaft)

1. Remove 2 screws on the top of the refrigerator.

2.  Remove the plastic cover and make sure to 

disconnect the wire connected to it.
After removing the plastic cover, check the parts 
for reversing the door.

 Be careful not to damage the electrical 
wires when removing the plastic cover.

3. Disconnect the wires and then remove 3 bolts.

Make sure your refrigerator is unplugged 
before handling electrical wires.

4.  Remove the door from the lower hinge by carefully 

lifting the door straight up.

Refrigerator door is heavy, be careful 
not to injure yourself when removing the 
refrigerator door. 

5.  Separate the front leg cover after removing

2 screws.

6.  Unscrew 3 bolts tightening the hinge and also 

unscrew 3 bolts on the bottom left side by the front 
leg where removed hinge will be attached.

WARNING

CAUTION

Screw

10mm

10mm

WARNING

CAUTION

Screw

DA99-01950G-09.indb   Sec4:7

DA99-01950G-09.indb   Sec4:7

13. 7. 2.   

 11:04

13. 7. 2.   

 11:04