Samsung RS727CQRBSLA Manuel D’Utilisation
08_
setting up
2. Remove two water lines (White one is for water
and the other one is for ice) by pressing the
coupler ( 1 ) and pulling the water line ( 2 ) away.
coupler ( 1 ) and pulling the water line ( 2 ) away.
Reattaching the Water Supply Line
1. The Water Line must be fully inserted to the
Center of transparent coupler to prevent water
leakage from the dispenser.
leakage from the dispenser.
2. Insert the 2 clips in the install pack and check
that each clip holds the line firmly.
Do not cut the water line. Gently separate it
from the coupler.
from the coupler.
Removing the freezer door
A few things to mention fi rst.
• Make sure that you lift the door straight up so the
• Make sure that you lift the door straight up so the
hinges are not bent or broken.
• Be careful not to pinch the water tubing and wire
harness on the door.
• Place doors on a protected surface to prevent
scratching or damage.
SETTING UP THE
REFRIGERATOR
REFRIGERATOR
Now that you have your new Refrigerator installed in
place, you are ready to set up and enjoy the features
and functions of the appliance. By completing the
following steps, your Refrigerator should be fully
operational. If not, fi rst check the power supply and
electricity source or try the troubleshooting section
at the back of this user’s guide. If you have any
further questions, contact your Samsung Electronics
service center.
1. Place the Refrigerator in an appropriate location
place, you are ready to set up and enjoy the features
and functions of the appliance. By completing the
following steps, your Refrigerator should be fully
operational. If not, fi rst check the power supply and
electricity source or try the troubleshooting section
at the back of this user’s guide. If you have any
further questions, contact your Samsung Electronics
service center.
1. Place the Refrigerator in an appropriate location
with reasonable clearance between the wall and
the Refrigerator. Refer to installation instructions
in this manual.
the Refrigerator. Refer to installation instructions
in this manual.
2. Once the Refrigerator is plugged in, make sure
the interior light comes on when you open the
doors.
doors.
3. Set the Temperature control to the coldest
temperature and wait for an hour. The Freezer
will get slightly chilled and the motor will run
smoothly.
will get slightly chilled and the motor will run
smoothly.
4. After powering the Refrigerator, it will take a few
hours to reach the appropriate temperature. You
can store food and drinks in the Refrigerator after
the temperature is sufficiently cool.
can store food and drinks in the Refrigerator after
the temperature is sufficiently cool.
SETTING UP THE
REFRIGERATOR DOORS
REFRIGERATOR DOORS
If your entrance won’t allow the refrigerator to pass
easily through it, you can remove the doors.
easily through it, you can remove the doors.
Separating the Water Supply Line
from the Refrigerator
1. Pull the two water lines (which are in the Fixer)
out to the front.
Center of transparent coupler
Center of transparent coupler
clip A (¼”)
clip A (¼”)
(6.35mm)
(6.35mm)
(6.35mm)
clip A (¼”)
clip A (¼”)
(6.35mm)
(6.35mm)
(6.35mm)
1
2
Make sure the color of the
Make sure the color of the
water lines match.
water lines match.
water lines match.