Samsung RL48RECPN Manuel D’Utilisation
safety information _03
- Never start up an appliance showing any signs of
damage. If in doubt, consult your dealer.
The room where the refrigerator will be sited must
be 1m³ in size for every 8g of R600a refrigerant
inside the appliance.
The amount of refrigerant in your particular
appliance is shown on the identification plate
inside the appliance.
The room where the refrigerator will be sited must
be 1m³ in size for every 8g of R600a refrigerant
inside the appliance.
The amount of refrigerant in your particular
appliance is shown on the identification plate
inside the appliance.
- If the appliance contains isobutane refrigerant
(R600a), a natural gas with high environmental
compatibility that is, however, also combustible.
When transporting and installing the appliance,
care should be taken to ensure that no parts of
the refrigerating circuit are damaged.
compatibility that is, however, also combustible.
When transporting and installing the appliance,
care should be taken to ensure that no parts of
the refrigerating circuit are damaged.
• Contains fluorinated greenhouse gases covered
by the Kyoto Protocol.
• Hermetically sealed system.
• Do not vent gases into the atmosphere.
• Do not vent gases into the atmosphere.
Refrigerant type: R-134a
Quantity: 0.145kg
Global Warming Potential (GWP) = 1300
Quantity: 0.145kg
Global Warming Potential (GWP) = 1300
• Foam blown with fluorinated greenhouse gases.
SEVERE WARNING SIGNS
FOR INSTALLATION
FOR INSTALLATION
• Do not install this appliance in a humid, oily
or dusty location, in a location exposed to
direct sunlight and water (rain drops).
direct sunlight and water (rain drops).
- Deteriorated insulation of electrical parts may
cause an electric shock or fire.
• Do not place this refrigerator in direct sunlight or
expose to the heat from stoves, room heaters or
other appliances.
other appliances.
• Do not plug several appliances into the same
multiple power board.
The refrigerator should always be plugged into
its own individual electrical outlet which has a
voltage rating that matched the rating plate.
The refrigerator should always be plugged into
its own individual electrical outlet which has a
voltage rating that matched the rating plate.
- This provides the best performance and also
prevents overloading house wiring circuits, which
could cause a fire hazard from overheated wires.
If the wall socket is loose, do not insert the power
plug.
could cause a fire hazard from overheated wires.
If the wall socket is loose, do not insert the power
plug.
- There is a risk of electric shock or fire.
• Do not use a cord that shows cracks or abrasion
• Do not use a cord that shows cracks or abrasion
damage along its length or at either end.
• Do not bend the power cord excessively or place
heavy articles on it.
• Do not use aerosols near the refrigerator.
- Aerosols used near the refrigerator may cause an
- Aerosols used near the refrigerator may cause an
explosion or fire.
• Do not install this appliance in a location where
gas may leak.
- This may result in an electric shock or fire.
• The installation or any service of this
appliance is recommended by a qualified
technician or service company.
technician or service company.
- Failing to do so may result in an electric shock,
fire, explosion, problems with the product, or
injury.
injury.
• This refrigerator must be properly installed and
located in accordance with the manual before it
is used.
is used.
• Connect the power plug in proper position with
the cord hanging down.
- If you connect the power plug upside down, wire
can get cut off and a cause fire or an electric shock.
• Make sure that the power plug is not squashed
or damaged by the back of the refrigerator.
• When moving the refrigerator, be careful not to
roll over or damage the power cord.
- This constitutes a fire hazard.
• The appliance must be positioned so that the
• The appliance must be positioned so that the
plug is accessible after installation.
• This appliance should be positioned in such a
way that it is accessible to the power plug.
- Failing to do so may result in an electric shock or
fire due to electric leakage.
• The refrigerator must be grounded.
- You must ground the refrigerator to
- You must ground the refrigerator to
prevent any power leakages or electric
shocks caused by current leakage from
the refrigerator.
shocks caused by current leakage from
the refrigerator.
• Never use gas pipes, telephone lines or other
potential lightening rods as ground.
- Improper use of the ground plug can result in an
electric shock.
• If the power cord is damaged, have it
replaced immediately by the manufacturer
or its service agent.
or its service agent.
• The fuse on the refrigerator must be changed by
a qualified technician or service company.
- Failing to do so may result in an electric shock or
personal injury.
CAUTION SIGNS FOR
INSTALLATION
INSTALLATION
• Keep ventilation opening in the appliance
enclosure or mounting structure clear of
obstruction.
obstruction.
• Allow the appliance to stand for 2 hours after
installation.
CAUTION
WARNING
DA99-03458D-05.indb 03
DA99-03458D-05.indb 03
15. 5. 14.
5:46
15. 5. 14.
5:46