Samsung RL70LBPN Manuel D’Utilisation

setting up 

01

 

SETTING

 UP

refrigerator.  
It is not provided with your new 
refrigerator. The filter cartridge (

8) 

and holder (

9) kit can be purchased 

from the retailer where you 
purchased this refrigerator.

•  Do not use copper line.

•  Cut the tubing, making sure the 

ends are square and clean.

•  Connect the plastic line 

on the back of your 
fridge to the cartridge 
holder outlet (fully insert 
the plastic line to the 
cartridge holder outlet).

•  Insert plastic clip to the 

cartridge holder inlet and 
outlet.

•  Turn water on and check 

for any leakage.

•  You can purchase the necessary filter 

cartridge at the retailer where you 
purchased this refrigerator. Make sure 
you buy the SAMSUNG filter cartridge 
(Replacement cartridge No : DA29-
00015A) to ensure the best performance.

•  Water line must be connected to drinkable water 

only

•  A compression fitting and nut kit is supplied with 

the unit and it is inside the fridge drawer.

•  When pushing the Refrigerator back, make sure 

you don’t roll over the power cord or water line 
(Icemaker supply line)

To use without the water filter

•  Shut off the main water 

supply line and turn the Ice 
maker to the off position.

•  Locate the nearest cold 

water drinking line.

•  To prevent burns and product damage, do not 

hook up the water line to the hot water line.

•  Do not install the water line in areas where 

temperatures fall below freezing.

•  When using any electrical device (such as a 

power drill) during installation, be sure the device 
is insulated or wired in a manner to prevent 
electric shock.

•  All installations must be in a accordance with 

local plumbing code requirements.

•  Water line Kit and water filter are not 

covered by Samsung’s Warranty. The 
manufacturer (or dealer, installer) of them is 
responsible for any defects and all the loss 
caused by water filter & water line kit.

•  The filter should be replaced should be replaced 

according to manufacturer (or dealer)’s instruction.

•  To order additional water filters, please contact 

the manufacturer (or dealer) of the filter.

Using the water filter (not provided)

Connecting to water supply line

•  Shut off the main water supply 

line and turn the Ice maker to 
the off position.

•  Locate the nearest cold 

drinking water line.

•  Follow the instructions in the 

water filter installation kit.

•  After connecting the water 

supply line to the Cartridge 
Holder inlet and installing the 
Filter Cartridge (insert plastic 
line in fully).

•  Turn on water supply and flush 

3L into a bucket to clear the 
water filter.

•  The water filter must be installed outside the 

Water line fixer and screws

Pipe connector

Water line

90 degree

1.  Cold Water line
2.  Pipe Clamp.
3.  Plastic line
4.  Compression Nut
5.  Compression Sleeve
6.  Packing Nut
7.  Shut Off Valve
8.  Filter Cartridge
9.  Cartridge Holder

Cartridge Holder

Clip

Filter 
cartridge

Plastic line 

(Provided)

1.  Cold Water line
2.  Pipe Clamp.
3.  Plastic line
4.  Compression Nut
5.  Compression Sleeve
6.  Packing Nut.
7.  Shut Off Valve

DA68-01817M-EN.indd   7

2011.1.11   5:14:14 PM