Samsung 120 W 2.2Ch Micro Component MM-J430D Manuel D’Utilisation
English
9
|
Rear Panel
1. DC 24V (Power Supply In)
• Connect the DC power adaptor to the power
supply jack, and then connect the AC power
adaptor plug to a wall outlet.
adaptor plug to a wall outlet.
2. 2.0 CH Speaker Connector Terminals
The speaker connector terminals are located on
the rear of the system.To achieve the correct
sound quality, insert the speaker connector
cables identified below into the correct speaker
terminals on the back of the system.
the rear of the system.To achieve the correct
sound quality, insert the speaker connector
cables identified below into the correct speaker
terminals on the back of the system.
• Left speaker (marked L).
• Right speaker (marked R).
• Right speaker (marked R).
3. ONLY FOR SERVICE
• This jack is for service only. Please do not
use.
4. FM Antenna Connector Terminal
1. Connect the FM antenna (supplied) to the
FM Antenna jack.
2. Slowly move the antenna wire until you find
a location where reception is good, then
fasten it to a wall or other rigid surface.
fasten it to a wall or other rigid surface.
3. If reception is poor, you may need to install
an outdoor antenna. To do so, connect an
outdoor FM antenna to FM antenna jack on
the rear of the system using a 75Ω coaxial
cable (not supplied).
outdoor FM antenna to FM antenna jack on
the rear of the system using a 75Ω coaxial
cable (not supplied).
5. HDMI OUT Jack
Outputs digital video and audio signals
simultaneously using an HDMI cable.
simultaneously using an HDMI cable.
6. VIDEO OUT Jack
Connect your TV's Video Input jack (VIDEO IN) to
the VIDEO OUT jack.
the VIDEO OUT jack.
7. COMPONENT VIDEO OUTPUT Jacks
Connect a TV with Component video inputs to
these jacks.
these jacks.
Accessories
Check for the supplied accessories below.
Video Cable
FM Antenna
User's Manual
Remote Control/
Batteries
DC Adapter
Power Cord
2
3
4
1
5
7
6
6
02876J MM-J430D-XA-ENG-20150918.indd 9
2016/2/3 19:09:30