Samsung RH22H8010SR Guide D’Installation Rapide

ENGLISH

•  Insert a fl at-blade screwdriver 

into a slot on the control lever. 
Turn it clockwise or counter-
clockwise to level the refrigerator.

Leg

Screw Driver

•   Allow your refrigerator to operate and cool down for 24 

  hours (1 full day) before dispensing large quantities of 

  ice.

•   To fill the ice bucket to maximum capacity, dispense a 

  few cubes 8 and 16 hours after installation.

(This image may 

differ, depending

on the model.)

•   If 

ICE OFF  is lit, the ice maker will not make ice.

•   To activate the ice maker, press the 

ICE OFF   button on 

  the control panel so it is no longer lit.

•  If the water filter is clogged, the ice maker may produce small ice cubes 

 or ice cubes with bubbles.

•  Replace the water filter cartridge with a new one.

• For details, see "Changing the Water Filter" in the User 

Manual.

• If you have trouble inserting the water filter because of 

  the water supply valve.

• After installation or after replacing the water filter, 

dispense at least 1 gallon (about 6 minutes). of water 

to remove trapped air from the water line. Otherwise, 

water may drip from the dispenser after you dispense 

water. 

•   The first glass of water may not be cold enough because the water 

stored in the water tank has not cooled completely. Dispense several 
glasses of water until the water is cool to your liking.

•   After your refrigerator is installed, dispense at least 1 gallon 

of water from the water dispenser to remove air from the 
water line. If there is air in the water line, water can drip from 
the dispenser.

•   If the water line is not inserted into the coupler properly, air 

could penetrate into the water line causing water to drip 
from the water dispenser. 

•   Insert the water line into the coupler completely and slide in 

the clip at the end of the coupler.

Make sure the 
color of the 
water lines 
match.

1.  The Water Line must be fully inserted into the center of the 

 transparent coupler (Type A) or to the Guide Lines (Type B) to 
 prevent water leakage from the dispenser.

2.  Insert the clip from the install pack and confirm that it holds the 

 line firmly.

Center of Transparent coupler

The Guide Lines

Dispenser

clip A (1/4”) (6.35 mm)

Type A

Type B

• When you reassemble the water line, connect tubing of the 

same color together and seat the lines in the hook.

• Keep the clips out of the reach of children and make sure that 

children do not play with them or put them into their mouths.

to reach the temperature you set.

• When you put room temperature or warmer food into your refrigerator, it 

may need an additional 24 hours to reach the set temperature.

• You may hear these noises occasionally from inside the refrigerator. This 

is normal. These sounds occur when various items contract or expand 
while temperatures inside the fridge are changing, especially during 
defrosting. You may also hear these noises when electronic devices, 
including the ice maker, are operating.

• For details, see "Using the Control Panel" in the User Manual.

• Filter indicator : The filter Indicator turns red after you have 

dispensed about 300 gallons of water or after about 6 months has 

passed. Reset the indicator after replacing the filter by holding the 

“Energy Saver”  or  “Lighting”  button for 3 seconds, depending

on your model. The indicator will turn blue or off.

  : Press the 

 ”

 .

  (Show Room) mode : If the Display shows the 

  function is activated and the 

  mode, press the 

  in the table 

below simultaneously for 5 seconds.

RS22H** / RSG257**

Power Freeze + Freezer

Energy Saver

RH22H** / RH29H** / 

RH30H**

Lighting + Freezer + 

Fridge

Lighting

• If food with too much moisture is stored near the cooling vents, it may 

freeze. Be sure to keep moist food away from the cooling vents.

• When moving the refrigerator, pull or push it straight forwards or back. 

Do not wiggle it from side to side.

DA68-01517H-08

DA68-01517H-08.indd   1