Samsung Addwash Front Loader, 11kg Guide D’Installation Rapide

DC68-03704C-00



 Revise el otro lado.   Vérifiez l’autre côté.

5

English

To add laundry after a wash starts, use the Add Door.

You can open the Add Door when the Add Door icon ( 

 ) lights up on the display.

1.  Press Start/Pause to stop the wash cycle.
2.  Press the upper area of the Add Door to unlock the door. The door will move 

inward slightly when you press it, and then open.

3.  Open the Add Door fully, and then insert additional laundry through the Add 

Door into the drum.

4.  Lift the Add Door back into position, and then lock the door by pushing the 

upper area of the door until you hear a click.

5.  Press Start/Pause again to resume the wash cycle.

NOTE

The water inside the drum does not leak if the Add Door is closed properly. Water 
drops may form around the Add Door, but the water will not leak from inside the 
drum. This is normal.

The Add Door does not open and the ddC message appears.  

This message appears if you attempt to open the Add Door while the machine is 
operating. The machine senses the Add Door is slightly open and stops operating for 
safety reasons.
If this happens, close the Add Door, and then press Start/Pause to resume operation.

When can’t I open the Add Door?

You cannot open the Add Door:
•  When the Sanitize or Steam cycle is running and the internal temperature is 

high.

•  During a Self-clean cycle. When you run a self-cleaning cycle, the washer must 

be empty.

CAUTION

Do not press the Add Door to open it while a Sanitize or Steam cycle is running. Hot 
steam may leak out of the window.

Label_AddWash-03704C-00_20160111.indd   1

2016-01-26   �� 6:53:28