Samsung RS5000H FSR with Foodshowcase, 25.4 cu. ft. Manuel D’Utilisation

Page de 80
English - 38
Troubleshooting
PROBLEM
SOLUTION
The refrigerator 
does not work at 
all or it does not 
chill sufficiently.
•  Check that the power plug is properly connected.
•  Is the temperature control on the display panel set to the correct 
temperature?  
Try setting it to a lower temperature.
•  Is the refrigerator in direct sunlight or located too near a heat source? 
If so, it may not be able to cool sufficiently. Install it in a location that is out 
of direct sunlight and not near a heat source.
•  Is the back of the refrigerator too close to the wall,  preventing proper 
ventilation?  
If so, it may not be able to cool sufficiently. Keep it an appropriate 
distance from the wall.
•  Is there too much food inside so that the food is blocking the outlet vent?  
To keep the refrigerator at a suitable temperature, do not fill the 
refrigerator with too much food.
The food in the 
fridge is frozen.
•  Is the temperature control on the display panel set to the correct 
temperature?  
Try setting it to a warmer temperature.
•  Is the temperature in the room very low?
•  Did you store the food with a high water content in the coldest part of the 
fridge?  
Try moving those items into the body of the fridge instead of keeping them 
in the CoolSelect Zone™ drawer.
You hear unusual 
noise or sounds.
•  Check that the refrigerator is level and stable.
•  Is the back of the refrigerator too close to the wall and therefore keeping 
air from circulating?
•  Was anything dropped behind or under the refrigerator?
•  A “ticking” sound is heard from inside the refrigerator. This is normal and 
occurs because various accessories are contracting or expanding in 
relation to the temperature of the refrigerator interior.
The front corners 
of the appliance 
are hot and 
condensation is 
occurring.
•  Some heat is normal as anti-condensators are installed in the front 
corners of the refrigerator to prevent condensation.
•  Is the refrigerator door ajar? Condensation can occur when you leave the 
door open for a long time.
Ice is not 
dispensing.
•  Did you wait for 12 hours after installation of the water supply line before 
making ice? 
It may take longer to make ice if it is not sufficiently cool, such as when 
first installed.
•  Is the water line connected and the shut-off valve open?
•  Did you manually stop the ice making function? Make sure Ice Type is set 
to Cubed or Crushed.
•  Is there any ice blocked within the ice maker bucket?
•  Is the freezer temperature too warm? Try setting the freezer temperature 
lower.
SSEDA FSR-1 EN-���.indd   38
14. 11. 28.   �� 1:11