Samsung RF263 Tipo Europeo con Twin Cooling Plus™, 682 L Manuel D’Utilisation

10_

setting up

it straight forwards or back. Do not wiggle it from
side to side.

REMOVING THE
REFRIGERATOR DOORS

For some installations you need to remove the
fridge and freezer drawers so you can move the
refrigerator to its ﬁ nal location. Do not remove
the doors/drawer if you don’t need to. If you do
not need to remove the refrigerator doors, go to
Adjusting the Level on page 12. If you need to
remove the doors. continue below.
Before removing the door/drawer, make sure you

read the following items:

Required Tools (Not provided)

You need the following tools to complete the
installation of your refrigerator:

Philips

screwdriver(+)

Flat-blade screw

driver(-)

Socket wrench

(10 mm)

Pliers

Allen wrench

(5 mm)

Disconnect power to the refrigerator before
removing the door or drawer.

• Be careful not to drop, damage or

scratch the door/drawer while removing
them.

Be careful not to get injured while removing the

•

door/drawer.
Reattach the door/drawer properly to avoid:

•

Moisture from air leakage.

Uneven door alignment.

Wasting energy due to improper door seal.

WARNING

Disassemble the refrigerator doors

Be careful not to drop and scratch the
doors while removing the doors.

With the door opened

Remove 3 screws holding down the TOP

TABLE ( 1 ) and turn it with wires connected.

Disconnect two connector (

2. 2

) on the left side

door. To remove the water coupler from the
hinge, twist and pull it from the hinge. Remove
the water line ( 3 ) while pressing the marked
part ( 4 ) of the water line coupler.

If a red clip is on the coupler, it must be
removed before removing the tube.

Pull and remove the hinge lever (

3. 5 ) . Remove

the ground screw ( 6 ) attached to the upper
left door hinges with a philips screwdriver (+).
Remove the upper left and right door hinges
( 7 ).

WARNING

CAUTION

Red Clip

(1/4")

DA68-02615A(0.0).indb 10

2012.7.11 8:41:4 PM