Samsung RF62QERS Manuel D’Utilisation
safety information
_03
After reading this section,
keep it in a safe place for
future reference.
keep it in a safe place for
future reference.
CE Notice
This product has been
determined to be in
compliance with the Low
Voltage Directive(2006/95/
EC), the Electromagnetic
Compatibility Directive
(2004/108/EC), RoHS
Directive (2011/65/EU),
Commission Delegated
Regulation (EU) No 1060/2010
and the Eco-Design
Directive(2009/125/EC)
implemented by Regulation
(EC) No 643/2009 of the
European Union. (For products
sold in European Countries
only)
compliance with the Low
Voltage Directive(2006/95/
EC), the Electromagnetic
Compatibility Directive
(2004/108/EC), RoHS
Directive (2011/65/EU),
Commission Delegated
Regulation (EU) No 1060/2010
and the Eco-Design
Directive(2009/125/EC)
implemented by Regulation
(EC) No 643/2009 of the
European Union. (For products
sold in European Countries
only)
SEVERE WARNING
SIGNS FOR
TRANSPORTATION AND
SITE
• When transporting and
installing the appliance,
care should be taken to
ensure that no parts of
the refrigerating circuit are
damaged.
care should be taken to
ensure that no parts of
the refrigerating circuit are
damaged.
- Refrigerant leaking from the
pipe work could ignite or
cause an eye injury. If a leak
is detected, avoid any naked
flames or potential sources
of ignition and air the room
in which the appliance is
standing for several minutes.
is detected, avoid any naked
flames or potential sources
of ignition and air the room
in which the appliance is
standing for several minutes.
• In order to avoid the creation
of a flammable gas-air mixture
if a leak in the refrigerating
circuit occurs, the size of the
room in which the appliance
may be sited depends on the
amount of refrigerant used.
if a leak in the refrigerating
circuit occurs, the size of the
room in which the appliance
may be sited depends on the
amount of refrigerant used.
• Never start up an appliance
showing any signs of damage.
If in doubt, consult your
dealer. The room where the
refrigerator will be sited must
be 1m³ in size for every 8g
of R600a refrigerant inside
the appliance. The amount of
refrigerant in your particular
appliance is shown on the
identification plate inside the
appliance.
If in doubt, consult your
dealer. The room where the
refrigerator will be sited must
be 1m³ in size for every 8g
of R600a refrigerant inside
the appliance. The amount of
refrigerant in your particular
appliance is shown on the
identification plate inside the
appliance.
SEVERE WARNING
SIGNS FOR
INSTALLATION
• Do not install the
refrigerator in a damp
place or place where it
may come in contact with
water.
place or place where it
may come in contact with
water.
- Deteriorated insulation of
WARNING
WARNING