Samsung RS61781GDSL Manuel D’Utilisation
16_
setting up
16_
setting up
4. After connecting the water supply to the water
filter, turn your main water supply back on and
Dispense about 3L to clear and prime the water
filter.
Dispense about 3L to clear and prime the water
filter.
INSTALLING THE WATER
DISPENSER LINE
DISPENSER LINE
Connecting the water line to the
refrigerator
refrigerator
1. Remove the cap from water line on the unit and
insert compression nut to the water line on the
unit after disassembling from provided water line.
unit after disassembling from provided water line.
2. Connect both water line from the unit and water
line in the kit
3. Tighten the compression nut onto the
compression fitting. Be careful no gap between
two items.
two items.
4. Turn water on and check for any leakage.
CHECKING THE WATER
DISPENSER LINE
DISPENSER LINE
A water dispenser is just one of the helpful features
on your new Samsung refrigerator. To help promote
better health, the Samsung water fi lter removes
unwanted particles from your water. However, it
does not sterilize or destroy microorganisms. You
will need to purchase a water purifying system to do
that.
on your new Samsung refrigerator. To help promote
better health, the Samsung water fi lter removes
unwanted particles from your water. However, it
does not sterilize or destroy microorganisms. You
will need to purchase a water purifying system to do
that.
In order for the icemaker to operate properly, water
pressure of 138 ~862 kPa is required. Under normal
conditions, a 170 cc paper cup can be fi lled in 10
seconds.
pressure of 138 ~862 kPa is required. Under normal
conditions, a 170 cc paper cup can be fi lled in 10
seconds.
If the refrigerator is installed in an area with low water
pressure (below 138 kPa), you can install a booster
pump to compensate for the low pressure.
pressure (below 138 kPa), you can install a booster
pump to compensate for the low pressure.
Make sure the water storage tank inside the
refrigerator is properly fi lled. To do this, press the
water dispenser lever until the water runs from the
water outlet.
refrigerator is properly fi lled. To do this, press the
water dispenser lever until the water runs from the
water outlet.
Water Line installation Kits are included with
unit. You can fi nd it in freezer(or fridge) drawer.
unit. You can fi nd it in freezer(or fridge) drawer.
The new hose-sets supplied with the
appliance are to be used and that old hose-
sets should not be reused.
appliance are to be used and that old hose-
sets should not be reused.
Parts for water line Installation
Connecting to the water supply line
1. First, shut off the main water supply line.
2. Locate the nearest cold, drinking water line.
3. Follow the Water Line Installation Instructions in
2. Locate the nearest cold, drinking water line.
3. Follow the Water Line Installation Instructions in
the installation kit.
1 Water line fixer
Water line fixer
and screws
and screws
and screws
2 Pipe connector
Pipe connector
3 Water line
Water line
4 Clip
Clip
5 Water Filter
Water Filter
CAUTION
The water line must be connected to
the cold water pipe.
If it is connected to the hot water pipe,
it may cause the purifier to malfunction.
the cold water pipe.
If it is connected to the hot water pipe,
it may cause the purifier to malfunction.
Close Main
Close Main
Water pipe
Water pipe
Water pipe
Close Main
Close Main
Water pipe
Water pipe
Water pipe
No gap
No gap
Remove
Remove
cap
cap
Water Line
Water Line
from unit
from unit
from unit
Water Line
Water Line
from Kit
from Kit
from Kit
No gap
No gap
Loosen a
Loosen a
DA99-04031C-11.indb
2:16
DA99-04031C-11.indb
2:16
2015. 5. 19.
3:29
2015. 5. 19.
3:29