Samsung In-Door Ice Maker Side-By-Side Guide D’Installation Rapide

Before installation or calling service

If you have further questions or your refrigerator has damaged accessories or parts, contact us at 1-800-SAMSUNG (726-7864).

ENGLISH

1. Leveling & Door Alignment

•  For details, refer to “Leveling 

the Refrigerator” in the User 
Manual.

•  Insert a fl at-blade screwdriver 

into a slot on the control lever. 
Turn it clockwise or counter-
clockwise to level the refrigerator.

Leg

Screw Driver

[For Store Installation Only]
When the refrigerator is empty, adjust the Leveling Leg 
Control by turning it clockwise or counterclockwise with 
a flat head screwdriver until the Leveling Legs contact 
the floor. This will allow better balance of the Refrigerator 
when it is empty. (RH22H**, RH29H**, RH30H**)

CAUTION

2. Automatic Ice Maker does not work

•  Allow your refrigerator to operate and cool down for 24 

hours (1 full day) before dispensing large quantities of 
ice.

•  To fi ll the ice bucket to maximum capacity, dispense a 

few cubes 8 and 16 hours after installation.

(This image may 

differ, depending

on the model.)

• If 

ICE OFF is lit, the ice maker will not make ice.

•  To activate the ice maker, press the ICE OFF button on 

the control panel so it is no longer lit.

3. Small ice cubes, ice cubes with bubbles, or slow 

•  If the water fi lter is clogged, the ice maker may produce small ice cubes 

or ice cubes with bubbles.

•  

Replace the water fi lter cartridge with a new one.

4. Water filter replacement

•  For details, see "Changing the Water Filter" in the User 

Manual.

•  If you have trouble inserting the water fi lter because of 

high water pressure, shut off  the water supply valve.

•  After installation or when replacing the water fi lter, 

dispense at least 1 gallon (6 minutes) of water to 
remove trapped air from the water line. Otherwise, 
water may drip from the dispenser after you dispense 
water. 

5. Water is not cool enough

•  The fi rst glass of water may not be cold enough because the water 

stored in the water tank has not cooled completely. Dispense several 
glasses of water until the water is cool to your liking.

6. Water dispenser dripping

•  After your refrigerator is installed, please fl ush 3 gallon of 

water to remove air from the water lines. If there is air in the 
water lines, water can drip from the dispenser.

•  If the water line is not inserted into the coupler properly, air 

could penetrate into the water line causing water to drip 
from the water dispenser. 

•  Insert the water line into the coupler completely and slide in 

the clip at the end of the coupler.

< RS models >

< RS models >

1

2

Make sure the 

Make sure the 
color of the 

color of the 
water lines 

water lines 
match.

match.

< RH models >

< RH models >

CAUTION

1.  The Water Line must be fully inserted into the center of the 

transparent coupler (Type A) or to the Guide Lines (Type B) to 
prevent water leakage from the dispenser.

2.  Insert the clip from the install pack and confirm that it holds the 

line firmly.

Center of Transparent coupler

The Guide Lines

Dispenser

clip A (1/4”) (6.35 mm)

clip A (1/4”) (6.35 mm)

Type A

Type B

•  When you reassemble the water line, connect tubing of the 

same color together and seat the lines in the hook.

•  Keep the clips out of the reach of children and make sure that 

children do not play with them or put them into their mouths.

7.  Fridge or Freezer Compartments are warm

•  Allow your refrigerator to operate and cool down for 24 hours (1 full day) 

to reach the temperature you set.

•  When you put room temperature or warmer food into your refrigerator, it 

may need an additional 24 hours to reach the set temperature.

8. Noise Clicks, Pops, Cracks, Snaps

•  You may hear these noises occasionally from inside the refrigerator. This 

is normal. These sounds occur when various items contract or expand 
while temperatures inside the fridge are changing, especially during 
defrosting. You may also hear these noises when electronic devices, 
including the ice maker, are operating.

9. Display

•  For details, see "Using the Control Panel" in the User Manual.
•  Filter indicator : The fi lter Indicator turns red after you have 

dispensed about 300 gallons of water or after about 6 months has 
passed. Reset the indicator after replacing the fi lter by holding the 
“Energy Saver” or “Lighting” button for 3 seconds. The indicator 
will turn blue or off .

• Ice 

off  : Press the “Ice Off ” button to turn the ice making function off .

• Cooling 

Off  (Show Room) mode : If the Display shows the “OFF or OF 

OF” code, it means that the Cooling Off  function is activated and the 
refrigerator is not cooling. To cancel the Cooling Off  mode, press the 
two or three buttons listed for your model under Cooling Off  in the table 
below simultaneously for 5 seconds.

 Model               Button

Cooling Off

Filter Reset (3 sec)

RS22H** / RSG257**

Power Freeze + Freezer

Energy Saver

RH22H** / RH29H** / 

RH30H**

Lighting + Freezer + 

Fridge

Lighting

10. Food stored in refrigerator is frozen

•  If food with too much moisture is stored near the cooling vents, it may 

freeze. Be sure to keep moist food away from the cooling vents.

11. Moving the Refrigerator

•  When moving the refrigerator, pull or push it straight forwards or back. 

Do not wiggle it from side to side.

DA68-01517H-07

CAUTION

CAUTION

CAUTION

DA68-01517H-07.indd   1

DA68-01517H-07.indd   1

2014. 11. 21.   

 11:53

2014. 11. 21.   

 11:53