Samsung Galaxy Stardust Documentation juridique

Additional information on the safety of RF exposures from various sources can be obtained from the 

following organizations (updated 12/31/2014):

 

●  FCC RF Safety Program: 

 

●  Environmental Protection Agency (EPA): 

 

●  Occupational Safety and Health Administration (OSHA):  

(Note: This web address is case sensitive.)

 

●  National Institute for Occupational Safety and Health (NIOSH): 

 

●  World Health Organization (WHO):  

 

●  International Commission on Non-Ionizing Radiation Protection: 

 

●  Health Protection Agency:  

 

●  US Food and Drug Administration:  

www.fda.gov/Radiation-EmittingProducts/RadiationEmittingProductsandProcedures/

HomeBusinessandEntertainment/CellPhones/default.htm

Your wireless device is a radio transmitter and receiver. It is designed and manufactured not to exceed 

the exposure limits for Radio Frequency (RF) energy set by the Federal Communications Commission 

(FCC) of the U.S. Government.
These FCC RF exposure limits are derived from the recommendations of two expert organizations: the 

National Council on Radiation Protection and Measurement (NCRP) and the Institute of Electrical and 

Electronics Engineers (IEEE). In both cases, the recommendations were developed by scientific and 

engineering experts drawn from industry, government, and academia after extensive reviews of the 

scientific literature related to the biological effects of RF energy.
The RF exposure limit set by the FCC for wireless mobile phones employs a unit of measurement known 

as the Specific Absorption Rate (SAR). The SAR is a measure of the rate of absorption of RF energy by 

the human body expressed in units of watts per kilogram (W/kg). The FCC requires wireless phones to 

comply with a safety limit of 1.6 watts per kilogram (1.6 W/kg).
The FCC SAR limit incorporates a substantial margin of safety to give additional protection to the public 

and to account for any variations in measurements.
SAR tests are conducted using standard operating positions accepted by the FCC with the phone 

transmitting at its highest certified power level in all tested frequency bands. Although the SAR is 

determined at the highest certified power level, the actual SAR level of the phone while operating can be 

well below the maximum reported value. This is because the phone is designed to operate at multiple 

power levels so as to use only the power required to reach the network. In general, the closer you are to 

a wireless base station antenna, the lower the power output of the device.