Samsung Front Load Washer With VRT

1

nd

The water level fails to drop below the 

Reset Water Level within 15 minutes.

Go to “ Will Not Drain” Troubleshooting 

Section. 

2

LO

Door fails to Unlock After 7 attempts. Go to “ Will Not Unlock” 

Troubleshooting Section.

3

nF

When the filling Continues for more 

than 40 minutes or there is no change 

of water level for 6 minutes.

Go to “ No Water Fill” Troubleshooting 

Section.

4

FL

Door fails to lock after 7 attempts.

Go to “ Will Not Lock” Troubleshooting 

Section.

5

LE

A water level lower than the Reset 

water level is detected for 5 seconds 

during the Wash/Rinse cycle.

Go to “No Water Fill” Troubleshooting 

Section.

6

1E

Water Level Sensor Trouble. (When 

the input signal from the water level 

sensor is out of range, the unit will 

send out beeping sounds and halts 

the cycle.)

Go to “No Water Fill”

Troubleshooting Section

7

OE

A fault is detected in the water level 

sensor. Data (frequency) shows the 

water level is at or above the overflow 

water level. (When this condition 

is detected, the machine will 

automatically starts draining water 

until the water level falls below the 

reset water level)

First check to see that all of water 

valves are not stuck. If water valves 

are OK, check water level.

8

dc

Unbalance or cabinet bump is 

detected during final spin, which 

prevents the drum from spinning over 

150 rpm. (Never exceeds 150 RPM due 

to unbalanced load)

Go to “Wet Clothes” Troubleshooting 

Section. 

9

E2

Jammed Key.(When key input signals 

are coming out for more than 30 

seconds, it is regarded as a jam.)

Check all of keys. If A key is sensed 

to be pressed, all keys will do not 

respond.

To avoid risk of electrical shock, personal injury or death; disconnect power to washer 

before servicing, unless testing requires power.

[BingBang] Technical_information_02830A-02_EN.indd   2

2012-10-05   �� 5:06:09