Samsung Dual Ice Maker French Door Guide D’Installation Rapide

ENGLISH

•  Allow  your  refrigerator  to  operate  and 

cool down for 24 hours (1 full day) be-
fore the ice maker starts producing ice.

•  To  fill  the  ice  bucket  to  maximum  ca-

pacity, dispense a few cubes 8 and 16 
hours after installation.

•  If 

ICE OFF is lit, the ice maker will not make ice.

• To activate the ice maker, press the 

ICE OFF 

but-ton on the control panel so it is no lon-
ger lit.

•  When installing, servicing or cleaning behind the 

refrigerator, be sure of the following:

•  To protect your floor's finish when moving the 

refrigerator, cut a large section of the cardboard 
carton and place under the refrigerator where 
you are working.

•  Pull the unit straight out and push back in 

straight after finishing.

•  Check if the ice bucket is completely 

inserted. (On some models)

•  Freezer  temp  may  not  be  enough; 

set it to -2ºF(-19ºC) or lower.

•  If the water filter is clogged, small or bubbled ice 

cubes may be produced.

•  Replace the water filter cartridge with a new one.

After installation or when replacing the 

water filter, dispense at least  

1 gallon (2~3minutes) of water to 

remove trapped air from the water line.  

Otherwise, water may drip after dis-

pensing water. (On some models)

•  The first glass of water may not be cold enough 

because the stored water in the water valve has 
not cooled completely. Dispense several glasses 
of water and then it would be cool.

1.  The Water Line must be fully Inserted to the center 

of transparent coupler to prevent water leakage 
from the dispenser.

2.  Insert the clip in the install pack and check that it 

holds the line firmly.

•  These  noises  may  be  heard  occasionally  inside 

the refrigerator. This is normal. This sound occurs 
when  various  items  contract  or  expand  while 
temperatures  are  changing;  especially  during 
defrosting. This may also occur when electronic 
devices including the ice maker are operating.

•  You can select your Pantry 

temperature from among the     
following.

Wine Party Dishes (38°F[3°C])
Fresh (38°F[3°C])
Chilled (34°F[1°C])
Deli (41°F[5°C])

•  Insert a flat-blade screwdriver into a slot on the 

control lever, turn it clockwise or counter-clock-
wise to level the door.

•  Open the freezer drawer to gain an access to the 

adjustable hinge pin. Next, adjust the refrigerator 
door using the provided 0.16 inch wrench.

RAISE

•  If you need to add more height to the door, insert 

the provided snap rings.

•  If the water line is not inserted into the coupler 

properly, air could penetrate into the water line 
causing water dripping from the water dispenser.

•  

CAUTION : Insert the water line into the coupler com-
pletely and slide in the clip at the end of the coupler.

Red Clip 

(1/4")

Dispenser 
Door Tube

Cabinet 
Tube

DA99-04014A  REV(0.3) 

•  Slowly  turn  the  water  filter  90° 

clockwise so it is aligned with the 

printing  mark  on  the  cover,  lock-

ing the filter in position.

Make sure to align the water filter 

label mark with center of cover fil-

ter printing as illustrated.

•  If you are in trouble of inserting the 

water filter as high pressure of water, shut off the 

water supply valve. For details, refer to the “Chan-

gig the water filter” section of the User Manual.

•  For details, refer 

to the user manual “Adjusting the level”

•  Recommended Temp Settings : 0ºF(-18ºC) for 

freezer and 37ºF(3ºC) for refrigerator.

•  Filter indicator : The filter Indicator will be Red If you 

use water about 300 gallons (6 month) Reset the indi-
cator (it will be Blue) after replacing the filter by holding 
the "

Ice Type/Water/Hold 3 sec for Filter Reset" 

button for 3 seconds.

•  Ice  off  :  Press  the  “

Ice  Off”  button  to  turn  the  ice 

making function off.

The display may differ depending on models.
For details, refer to the user manual “Using the control 
panel.

Center of transparent coupler

clip A (1/4”) 
(6.35mm)

PUSH



Control Lever

Flat-blade screw driver(-)

<sample>

•  Allow your refrigerator to operate and cool down for 

24 hours (1 full day) to reach to the set temperature.

•  Also, when you put room temperature or warmer 

food into your refrigerator, it may need an additional 
24 hours for the fridge to reach the set temperature.

•  Wipe off the condensation with a dry towel (This 

may occur during hot and humid seasons.)

•  If the condensation occurs on the doors, turn off 

the Energy Saving function.

•  If you open the doors frequently or for too long, it 

may cause moisture inside the fridge.

•  If food with too much moisture is stored near the 

cooling vents, it may get frozen. Be sure to keep 
moist food away from the cooling vents.

DA99-04014A(EN+FR+ES)-0.3.indd   1

2012.4.2   1:55:39 PM