Samsung RT2ASATS2 Manuel D’Utilisation
warranty & service_13
warranty & service
trouBlEShooting
PROBLEM
SOLUTION
What should i do if the oven
doesn’t heat up?
doesn’t heat up?
• The oven may not be switched on. Switch the oven on.
• The clock may not be set. Set the clock (see section
“Time Setting”).
• Check to see if the required settings have been applied.
• A household fuse may have blown or a circuit breaker
may have tripped. Replace the fuses or reset the circuit.
If this happens repeatedly, call an authorised electrician.
What should i do if, even
though the oven function and
temperature have been set, the
oven does not heat up?
though the oven function and
temperature have been set, the
oven does not heat up?
• There may be problems with the internal electrical
connections. Call your local service centre.
What should i do if an error
code appears and the oven
does not heat up?
code appears and the oven
does not heat up?
• There is a fault in the internal electrical circuit
connection. Call your local service centre.
What should i do if the time
display is blinking?
display is blinking?
• There was a power failure. Set the clock (see section
“Time Setting”).
What should i do if the oven
light doesn’t illuminate?
light doesn’t illuminate?
• The oven light is faulty. Replace the oven light bulb (see
section “Bulb Exchange”).
What should i do if the oven’s
fan is running without having
been set?
fan is running without having
been set?
• Following use, the oven’s fan runs until the oven has
cooled down. Call your local service centre if the fan
continues to run after the oven has cooled down.
Error and SaFEty codES
CODE
PROBLEM
SOLUTION
An error of the oven may cause
low performance and problems
in safety. Stop using the oven
immediately.
Call local SAMSUNG service
centre.
SAFETY SHUTOFF
Oven has continued operating
at set temperature for prolonged
time.
Turn oven off and remove food.
Allow oven to cool before using
again.
If you did not select an appropriate
temperature for the mode.
Select the correct temperature for
the mode. (see section “Using the
Fast Preheating mode”)
1) * refers to all numbers or characters.
W
arran
T
y & ser
vice
BF1 Series_XEE-00352C_EN.indd 13
2011-06-27 8:22:26