Samsung RB34FERCDSA Manuel D’Utilisation
setting up
_17
01
SETTING
UP
• Remove paper on spacer and then
attach a spacer (Gray block) on the
back side of refrigerator for better
performance. Make sure a spacer
fix like above image when you install
the refrigerator. It is improving the
refrigerator performance.
(Only for RB31F***B, RB29F***B model)
back side of refrigerator for better
performance. Make sure a spacer
fix like above image when you install
the refrigerator. It is improving the
refrigerator performance.
(Only for RB31F***B, RB29F***B model)
• Allow sufficient space to the right, left,
back and top for air circulation.
This will help reduce power
consumption and keep your energy
bills lower.
This will help reduce power
consumption and keep your energy
bills lower.
• Do not install the refrigerator where the
• Please ensure that appliance can be moved
freely in the event of maintenance & service.
When installing, servicing, or cleaning
behind the refrigerator, be sure to pull the
unit straight out and push back in straight
after finishing.
Also, make sure your floor supports the
full-load refrigerator.
Otherwise, it may cause floor damage.
behind the refrigerator, be sure to pull the
unit straight out and push back in straight
after finishing.
Also, make sure your floor supports the
full-load refrigerator.
Otherwise, it may cause floor damage.
Please tie up the extra length of the power
cord at the back of the refrigerator so as
not to be touched on the floor preventing
the power cord from being crushed by the
rollers upon relocation.
cord at the back of the refrigerator so as
not to be touched on the floor preventing
the power cord from being crushed by the
rollers upon relocation.
CAUTION
CAUTION
FLOORING
For proper installation, this refrigerator must be
placed on a level surface of hard material that has
the same height as the rest of the flooring. This
surface should be strong enough to support a fully
placed on a level surface of hard material that has
the same height as the rest of the flooring. This
surface should be strong enough to support a fully
protect the floor finish, cut a large section of the
cardboard carton and place it under the refrigerator
where you are working.
cardboard carton and place it under the refrigerator
where you are working.
• Pulling or pushing the refrigerator may
damage the floor.
Moving the refrigerator after installation
may damage the floor.
Moving the refrigerator after installation
may damage the floor.
LEVELLING THE REFRIGERATOR
If the front of the appliance is slightly higher than
the rear, the door can be opened and closed more
easily.
the rear, the door can be opened and closed more
easily.
Case 1) The appliance tilts down to the left.
Turn the left adjusting leg in the direction of the
arrow until the appliance is level.
Turn the left adjusting leg in the direction of the
arrow until the appliance is level.
Case 2) The appliance tilts down to the right.
Turn the right adjusting leg in the direction of the
arrow until the appliance is level.
Turn the right adjusting leg in the direction of the
arrow until the appliance is level.
< Case2 >
< Case1 >
Spacer
Spacer
DA68-02833S-12.indb 17
2014. 5. 27.
5:19
For safety reasons, adjust the front side a little higher
than the rear side.
than the rear side.