Samsung RR19M1711DZ Manuel D’Utilisation

Page de 64
English  21
Installation
STEP 3 Adjust the levelling feet
Level the refrigerator by manually 
adjusting the levelling feet.
Turn the levelling feet clockwise to lower 
the position, or turn counter clockwise to 
raise. 
For safety reasons, adjust the front side a 
little higher than the rear side.
NOTE
This model does not allow for adjusting the 
front right foot that is fixed. Use the front 
left foot for levelling.
STEP 4 Initial settings
By completing the following steps, the refrigerator should be fully functioning.
1.  Plug the power cord into the wall socket to turn the refrigerator on.
2.  Open the door, and check if the interior light lights up.
3.  Set the temperature to the coldest, and wait for about an hour.
4.  Remove the 4 shipping caps from the shelf, which are attached for safe transportation.
5.  Wait until the refrigerator reaches the set temperature. 
Now the refrigerator is ready for use.
STEP 5 Final check
When installation is complete, confirm that:
•  The refrigerator is plugged into an electrical outlet and grounded properly.
•  The refrigerator is installed on a flat, level surface with a reasonable clearance from the 
wall or the cabinet.
•  The refrigerator is level and is sitting firmly on the floor.
•  The door opens and closes freely, and the interior light turns on automatically when 
you open the door.
OneDoor_RR1500K_DA68-03111C-03_EN.indd   21
2016-11-10     5:28:50