Panasonic KX-MB2061 Manuel D’Utilisation

To set the remote operation ID
A 3-digit remote access code must be entered when
operating the answering machine remotely. This code
prevents unauthorized parties from listening to your
messages remotely. The default setting is “111”.

Important:
R To prevent unauthorized access to this product,

1. MMENUN (soft key A) A M#NM3NM0NM6N
2. Enter the desired 3-digit remote access code.
3. MSAVEN (soft key A) A MOFFN

To deactivate remote operation
Press MGN in step 2 on “To set the remote operation
ID”, page 76.
R The entered remote access code is deleted.

Note:
R You can also program this feature with the base unit

To change the ring count in TAM/FAX mode
You can change the number of times the unit rings “Ring
count” before the unit answers a call.
You can select 2 to 4 rings, or “Toll saver”.
The default setting is “2 rings”.
“Toll saver”: The unit answers after 2 or 3 rings when
new messages have been recorded, and after 4 or 5
rings when there are no new messages. If you call your
unit from a remote location to listen to new messages
(page 73), you will know that there are no new messages
when the unit rings for the 4th time. You can then hang
up without being charged for the call.
1. MMENUN (soft key A) A M#NM2NM1NM1N
2. Select the desired setting. A MSAVEN (soft key A)

A MOFFN

Note:
R You can also program this feature with the base unit

To change the maximum recording time for
incoming messages
You can change the maximum message recording time
allowed for each caller. The default setting is “3 min”.
1. MMENUN (soft key A) A M#NM3NM0NM5N
2. Select the desired setting. A MSAVEN (soft key A)

A MOFFN

To select “Greeting only”
You can select “Greeting only” which sets the unit
to announce a greeting message to callers but not record
messages.

Select “Greeting only” in step 2 on “To change the
maximum recording time for incoming messages”,
page 76.

Note:
R When you select “Greeting only”:

– If you do not record your own message, the unit

will play the pre-recorded greeting-only message
asking callers to call again later.

– If you use your own message, record the

greeting-only message asking callers to call
again later (feature #302 on page 74).

R You can also program this feature with the base unit

Message alert
You can select whether or not the message indicator on
the cordless handset flashes slowly when new
messages are recorded. The default setting is “On”.

Important:
R If you stored the voice mail access number, the

1. MMENUN (soft key A) A M#NM3NM4NM0N
2. Select the desired setting. A MSAVEN (soft key A)

A MOFFN

Note:
R While message alert is on, battery operating time is

76