Benq S52 Instruction De Maintenance
Product System (PS)
Subject:
C4-425 Trouble Shooting Guide
Part No.:
99.K4501.000
Rev.: 0
Doc. No.
99.K4501.000-C4-425-001
Project Code:
99.K4501.001
Component Part.
No.:
NA
Page 30 of 35
Model Name:
DHS5
Form No: BQY0-0B-003-32(031205)
30
1.10 Cooling Module
To check if the computer’s cooling module is defective or malfunctioning, follow the troubleshooting
procedures below as instructed.
procedures below as instructed.
Procedure 1 Test Program Check
Procedure 2 Connector Check and Replacement Check
Procedure 1 Test Program Check
Execute the Fan On/Off test program available as part of the maintenance test program. This test
program checks the cooling module. Insert the diagnostics bootable CD in the computer's CD-ROM,
turn on the computer and run the test. See Diagnostic user guide for information on how to perform the
test.
If any error is detected by the test, go to Procedure 2.
Execute the Fan On/Off test program available as part of the maintenance test program. This test
program checks the cooling module. Insert the diagnostics bootable CD in the computer's CD-ROM,
turn on the computer and run the test. See Diagnostic user guide for information on how to perform the
test.
If any error is detected by the test, go to Procedure 2.
Procedure 2 Connector Check and Replacement Check
The cooling module is connected to the system board. If the cooling module malfunctions, there may be
a bad connection between the cooling module and the system board or either might be faulty.
Disassemble the computer following the steps described in Tear Down guide and perform the following
checks:
Check 1
The cooling module is connected to the system board. If the cooling module malfunctions, there may be
a bad connection between the cooling module and the system board or either might be faulty.
Disassemble the computer following the steps described in Tear Down guide and perform the following
checks:
Check 1
Make sure the cooling module has been firmly connected to the connector on the system
board. Also make sure that the tape is not stuck to any part of the fan and that the fan is
board. Also make sure that the tape is not stuck to any part of the fan and that the fan is