Alcatel-Lucent omniaccess 6000 Manuel D’Utilisation

Part 031639-00

May 2005

Prepare the supervisor slot.

The first supervisor card should be installed in Slot 0 of the Alcatel Wireless 
LAN Switch chassis. A second optional supervisor card can be installed in Slot 
1 if desired. Supervisor cards cannot be installed in Slot 2 or Slot 3.

If replacing a previously installed module, first see 

To install a module in an empty bay, first remove the blank cover plate. To do 
this, use a #2 Phillips or cross-head screwdriver to loosen both of the 
fastening screws on the blank cover plate. The screws loosen with 
counter-clockwise rotation but are captive and cannot be fully removed.

Carefully insert the supervisor card into the chassis slot.

Hold the supervisor card by the handle. Align the rear of the card with the 
guide-rails in the chassis slot and gently slide the module toward the 
backplane. Do not force the module; it should slide in easily most of the way.

Engage the supervisor card.

There may be moderate resistance when the supervisor card meets the 
connectors in the backplane. Press firmly so that the connectors at the back of 
the module engage with the backplane, but do not use excessive force.

If the system is powered up, the module’s Power LED will light up green if the 
supervisor card is inserted properly.

Secure the supervisor card.

Use a #2 Phillips or cross-head screwdriver to push in the captive fastening 
screws and turn them clockwise until moderate resistance is felt. Do not 
over-tighten.

Connect the appropriate network cables.

Supervisor card ports are described under 

 starting on 

.

—Verify that the fastening screws for the module above the 

supervisor card slot are fully secured. If the module in Slot 2 or Slot 3 
is loose, it could interfere with the new module insertion and possibly 
damage the components.