Alcatel-Lucent omniacces-voip gateway Manuel D’Utilisation
VoIP Commands
Page 5-164
Command Usage
Override call signaling for call progress tone detection configuration (default/alternate). This
command should only be used under the supervision of trained personnel.
command should only be used under the supervision of trained personnel.
Syntax Options
Remarks
This command is used to specify which configuration to use for call progress tone detection.
Each configuration contains filter information (threshold and filter coefficients), and a table
containing cadence information of all the call progress tones that need to be detected. The
information (call progress tones) is transferred as information type packets to a coding profile.
Full call progress tones means that all available call progress tones can be used in band. Each
configuration, whether default or alternate has a filter configuration for dial tone, ring back,
including three supported cadences, bust, and congestion.
Each configuration contains filter information (threshold and filter coefficients), and a table
containing cadence information of all the call progress tones that need to be detected. The
information (call progress tones) is transferred as information type packets to a coding profile.
Full call progress tones means that all available call progress tones can be used in band. Each
configuration, whether default or alternate has a filter configuration for dial tone, ring back,
including three supported cadences, bust, and congestion.
If the alternative tone detection configuration is selected, the tone detection process is limited
to a busy tone, and other detected tones are ignored.
to a busy tone, and other detected tones are ignored.
voice signaling override full call progress tones
voice signaling channel <
slot/port/startChannel-endChannel
>[no] override full call progress tones
[on | off]
Definitions:
slot
slot
Specifies chassis slot number where VSM is installed, (e.g.,
2
).
port
Specifies physical port number on voice daughtercard, (e.g.,
1
).
startChannel
The first number in the range of voice channels (e.g.,
1
).
endChannel
The last number in the range of voice channels (e.g.,
30
).
♦ Syntax Note ♦
Be sure to separate the start and end range numbers with a
hyphen (e.g.,
1-30
).
no
Optional command syntax.
♦ Syntax Note ♦
If
no
is used then ON and OFF cannot be specified.
on
Use full call progress tones for specified telephony signaling channel.
off
Use full call progress tones for specified telephony signaling channel.
Default:
The default setting is
The default setting is
no override full call progress tones
.
Command Examples:
voice signaling channel no override full call progress tones
voice signaling channel override full call progress tones on
voice signaling channel override full call progress tones on