Alcatel-Lucent OmniAccess 3500 Mode D'Emploi
OmniAccess 3500 Nonstop Laptop Guardian Release 1.2
Battery Information
Your OmniAccess 3500 NLG card has an internal Li-Ion rechargeable battery.
• The battery gets charged when the card is plugged into your laptop and the
laptop is powered on.
• The battery gets discharged when the 3G modem is on and one of the following
conditions holds:
− The card is not plugged into your laptop.
− The card is plugged into your laptop, the laptop is powered on, and the 3G
− The card is plugged into your laptop, the laptop is powered on, and the 3G
modem is transmitting at maximum power because network coverage is bad
at your current location.
at your current location.
− The card is plugged into your laptop, and the laptop is in
Standby/Hibernate/Shutdown mode.
• If the battery is out of charge, plug the card into the laptop, connect the laptop
to a power source, and leave the laptop powered up for at least two hours.
The battery has a limited number of charge cycles and may eventually need to be
replaced. Note that the battery is not user replaceable: if the battery stops working,
replaced. Note that the battery is not user replaceable: if the battery stops working,
please contact your IT administrator, which can make arrangements to have the
battery replaced and disposed of by your 3G service provider.
The battery can be damaged if the card is dropped or exposed to extreme
temperatures. Always try to keep the card at room temperature. A card with a hot or
cold battery may temporarily not work, even when the battery is fully charged. Li-Ion
batteries are particularly affected by temperatures below 0 °C (32 °F). The battery
should not be charged at temperatures below 0 °C (32 °F) or above 45 °C (113 °F).
Do not place your card in areas that may get very hot, such as on or near a cooking
battery replaced and disposed of by your 3G service provider.
The battery can be damaged if the card is dropped or exposed to extreme
temperatures. Always try to keep the card at room temperature. A card with a hot or
cold battery may temporarily not work, even when the battery is fully charged. Li-Ion
batteries are particularly affected by temperatures below 0 °C (32 °F). The battery
should not be charged at temperatures below 0 °C (32 °F) or above 45 °C (113 °F).
Do not place your card in areas that may get very hot, such as on or near a cooking
surface, cooking appliance, iron, or radiator. Keep you card away from fluids and
moisture.
moisture.
Appendix: Error Messages
The following error messages may be displayed on the bottom left of the main
OmniAccess 3500 NLG client GUI window:
OmniAccess 3500 NLG client GUI window:
• Error: Certificates not uploaded to the client card. Please use the NLG-
>Configure menu to upload certificates.
The certificates needed for authentication of the OmniAccess 3500 NLG card are
missing. Make sure you have the full set (CA Certificate, User Certificate, and
The certificates needed for authentication of the OmniAccess 3500 NLG card are
missing. Make sure you have the full set (CA Certificate, User Certificate, and
User Key) before trying to install them again. Contact your IT administrator if you
are missing any of the required items.
are missing any of the required items.
• Error: Card to certificate mapping failed at the gateway. Please contact your IT
Administrator.
The User Certificate currently installed in your card may be outdated or
incorrect. Contact your IT administrator to obtain a new User Certificate.
The User Certificate currently installed in your card may be outdated or
incorrect. Contact your IT administrator to obtain a new User Certificate.
18