ASUS rs160-s5 Manuel D’Utilisation

6-2

Chapter 6: RAID configuration

The motherboard comes with the following RAID solution:

• 

LSI1068 PCI-X SAS controller supports SAS disk drives and RAID0, RAID1, 

and RAID1E configuration.

RAID 0 

(Data striping) optimizes two identical hard disk drives to read and write 

data in parallel, interleaved stacks. Two hard disks perform the same work as a 

single drive but at a sustained data transfer rate, double that of a single disk alone, 

thus improving data access and storage. Use of two new identical hard disk drives 

is required for this setup.
RAID 1

 (Data mirroring) copies and maintains an identical image of data from one 

drive to a second drive. If one drive fails, the disk array management software 

directs all applications to the surviving drive as it contains a complete copy of 

the data in the other drive. This RAID configuration provides data protection and 

increases fault tolerance to the entire system. Use two new drives or use an 

existing drive and a new drive for this setup. The new drive must be of the same 

size or larger than the existing drive.
RAID 1-E 

(Enhanced RAID 1) has a striped layout with each stripe unit having a 

secondary (or alternate) copy stored on a different disk. You can use three or more 

hard disk drives for this configuration.

If you want to boot the system from a hard disk drive included in a created RAID 

set, copy first the RAID driver from the support CD to a floppy disk before you 

install an operating system to the selected hard disk drive. 

The motherboard supports SATA and SAS HDD for RAID set configuration. For 

optimal performance, install identical drives of the same model and capacity when 

creating a disk array.
Refer to section 

2.4 Hard disk drives for SATA / SAS hard disk drive installation.