ASUS vw195tl Manuel D’Utilisation

2-2

Chapter 2: Setup

The detachable arm / base of the VW195xL/VW202xL/VW225xL Series LCD 

monitor is specially designed for VESA wall mount. 
To detach the arm/base

1.  Lower the monitor to its lowest height, and then insert the monitor height 

adjustment lock (Figure 1).

2.  Have the front of the monitor face down on a table.
3.  Remove the rubbers in the four screw holes (Figure 2).
4.  Use a screwdriver to remove the two screws on the arm (Figure 2), then slide 

out the arm/base to detach it from the monitor (Figure 3).

•  For optimal viewing, we recommend that you look at the full face of the monitor, 

then adjust the monitor to the angle that is most comfortable for you.

•  Hold the base to prevent the monitor from falling when you change its angle.
•  You can tilt the monitor’s from -3º to 20º, swivel from left-to-right for 45º, and lift 

the monitor’s height for about 70mm.