ASUS wl-300 Manuel D’Utilisation
Chapter 3
12
ASUS SpaceLink Access Point
Chapter 3 - Access Point Manager
2. Click the IP Config tab and change
the IP address and subnet mask.
By default, the ASUS Access Point
Manager shows correct settings of
ASUS SpaceLink Access Points on
the same subnet. For example, if
your ASUS Access Point Manager
software is running on IP address
192.168.8.8 subnet mask
255.255.255.0, you can enter IP ad-
dress 192.168.8.9 (assuming that
it is not already assigned to another
network device), subnet mask
255.255.255.0. Usually, you should
use the same subnet mask as your
computer.
By default, the ASUS Access Point
Manager shows correct settings of
ASUS SpaceLink Access Points on
the same subnet. For example, if
your ASUS Access Point Manager
software is running on IP address
192.168.8.8 subnet mask
255.255.255.0, you can enter IP ad-
dress 192.168.8.9 (assuming that
it is not already assigned to another
network device), subnet mask
255.255.255.0. Usually, you should
use the same subnet mask as your
computer.
Note: If you cannot find any ASUS SpaceLink Access Points due to
a problem in the IP settings, push and hold the “Reset to Defaults”
over five seconds to restore factory default settings.
a problem in the IP settings, push and hold the “Reset to Defaults”
over five seconds to restore factory default settings.
When using the ASUS Access Point manager through a wireless con-
nection, set your IP to 192.168.39.X (X being any number 1-254 that
is not assigned to another device) if you still cannot connect to any
ASUS SpaceLink Access Points after using “Reset to Defaults”.
nection, set your IP to 192.168.39.X (X being any number 1-254 that
is not assigned to another device) if you still cannot connect to any
ASUS SpaceLink Access Points after using “Reset to Defaults”.
Searching for SpaceLink Access Points (Cont.)
Note: In some situations, the ASUS Access Point Manager can-
not retrieve the MAC address of your ASUS SpaceLink Access
Point. In this case, you should key it in manually. You can see
the MAC address on the sticker after removing the base of the
ASUS SpaceLink Access Point.
not retrieve the MAC address of your ASUS SpaceLink Access
Point. In this case, you should key it in manually. You can see
the MAC address on the sticker after removing the base of the
ASUS SpaceLink Access Point.
3. Enter the default password asus
(lower case) and click OK.
The password is required to make
setting changes.
setting changes.