autotech 10.998.232k Manuel D’Utilisation
Phone 949.240.4000 Fax 949.240.0450
32240-E Paseo Adelanto, San Juan Capistrano, CA 92675
4) Using one of the longer screws to make each hole,
and a shorter screw to mount, attach 3 dual and
1 single clip to the front wire guide as shown at
right. The holes can be made in the raised section
in the guide between the stock wire grooves. Note
the clip positions in the illustrations.
1 single clip to the front wire guide as shown at
right. The holes can be made in the raised section
in the guide between the stock wire grooves. Note
the clip positions in the illustrations.
5) Using the remaining 3 dual clips and 3 long screws,
complete the installation for the Shock Therapy®
wires for the rear engine bank by essentially re-
peating the process used in step 3.
wires for the rear engine bank by essentially re-
peating the process used in step 3.
Close-up of typical hole position in wire guide.
Close-up view of front bank clip positions.
Completed front bank installation
Completed installation.