3com corebuilder 10002211 Manuel D’Utilisation

 

C

 

ORE

 

B

 

UILDER

 

 6000 E

 

XTENDED

 

 S

 

WITCHING

 

 S

 

OFTWARE

 

 R

 

EVISION

 

 8.2.3 

 

If you have an LMM+ at a revision earlier than 1.21 (for revision 1 modules) 
or 2.12 (for revision 2 modules), call 3Com at 1-800-876-3266 and press 
option 2. 3Com will replace your LMM+ with an LMM+ at the correct 
revision, free of charge. (Contact 3Com at the same number to upgrade an 
LMM to an LMM+. There is a fee for this upgrade.)

 

Release 8.0.0 or greater of Extended Switching Software requires a 
minimum of 2 MB of memory on Ethernet/FDDI Switching Modules 
(EFSMs). Memory configuration may vary. If you have an EFSM with 1 MB of 
memory, you can order a memory upgrade. Contact your sales 
representative.

To determine the amount of memory on the EFSM, look at the lower ejector 
tab label or use the 

 

 command from the top level of the 

Administration Console. EFSMs with only 1 MB of memory have blank 
lower ejector tabs. EFSMs with a minimum of 2 MB of memory have “2MB” 
on the lower ejector tab labels.

 

CoreBuilder system software release 8.2.3 offers support for the following 
items:

 

■

 

Software support for protocol-based VLANs

 

■

 

Support for seven RMON data groups

 

■

 

IP interface configuration change

 

■

 

Routing on FESM Modules

 

■

 

Additional RMON MIB support

 

■

 

RMON support for FDDI switched ports

For more information about this release, see 

 

 

CoreBuilder system software release 8.2.0 supports the following items:

 

■

 

Fast Ethernet Switching Module (FESM)

 

■

 

FESM and FSM HSI Switch Engines

 

■

 

Ability to administer Fast Ethernet Ports

 

■

 

Bridge MIB support for the FESM