3com WX1200 3CRWX120695A Manuel D’Utilisation

After these commands are entered, when the user logs on, the MOTD 
banner is displayed, followed by the text Do you agree? If the user enters 
y, then the login proceeds; if not, then the user is disconnected.

You can configure a WX switch to use a Domain Name Service (DNS) 
server to resolve hostnames into their IP addresses. This capability is 
useful in cases where you specify a hostname instead of an IP address in a 
command. 

For example, as an alternative to the command ping 192.168.9.1, you 
can enter the command ping chris.example.com. When you enter ping 
chris.example.com, the WX switch's DNS client queries a DNS server for 
the IP address that corresponds to the hostname chris.example.com, then 
sends the ping request to that IP address.

The WX switch’s DNS client is disabled by default. To configure DNS:

„

Enable the DNS client. 

„

Specify the IP addresses of the DNS servers.

„

Configure a default domain name for DNS queries.

The DNS client is disabled by default. To enable or disable the DNS client, 
use the following command:

set ip dns {enable | disable}

You can configure a WX switch to use one primary DNS server and up to 
five secondary DNS servers to resolve DNS queries.

The WX switch always sends a request to the primary DNS server first. 
The WX switch sends a request to a secondary DNS server only if the 
primary DNS server does not respond. 

To add a DNS server, use the following command:

set ip dns server ip-addr {primary | secondary}

To remove a DNS server, use the following command:

clear ip dns server ip-addr