3com WX1200 3CRWX120695A Manuel D’Utilisation

A configuration file contains CLI commands that set up the WX switch. 
The switch loads a designated configuration file immediately after 
loading the system software when the software is rebooted. You also can 
load a configuration file while the switch is running to change the 
switch’s configuration.

When you enter CLI commands to make configuration changes, these 
changes are immediately added to the device’s running configuration but 
are not saved to the configuration file. 

This section describes how to display the running configuration and the 
configuration file, and how to save and load configuration changes. A 
procedure is also provided for resetting the WX switch to its factory 
default configuration.

To display the configuration running on the WX switch, use the following 
command:

display config [area area] [all]

The area area parameter limits the display to a specific configuration 
area. (For more information, see the 

.)

The all parameter includes all commands that are set at their default 
values. Without the all parameter, the display config command lists 
only those configuration commands that set a parameter to a value other 
than the default.

To display the running configuration, type the following command:

WX1200# display config
# Configuration nvgen'd at 2004-5-10 19:08:38
# Image 2.1.0
# Model WX1200
# Last change occurred at 2004-5-10 16:31:14
set trace authentication level 10
set ip dns server 10.10.10.69 PRIMARY
set ip dns server 10.20.10.69 SECONDARY
set ip route default 10.8.1.1 1
set log console disable severity debug
set log session disable severity alert
set log buffer enable severity error messages 200
set log trace disable severity error mbytes 10