3com WX1200 3CRWX120695A Manuel D’Utilisation

C

HAPTER

 27: M

ANAGING

 S

YSTEM

 F

ILES

In the event that part of the configuration file is invalid or otherwise 
unreadable, MSS stops reading information in the configuration file and 
does not use it. You can optionally specify a backup file to load if MSS 
cannot load the original configuration file.

To specify a backup configuration file, use the following command:

set boot backup-configuration filename

To specify a file called backup.cfg as the backup configuration file, use 
the following command:

WX1200# set boot backup-configuration backup.cfg
success: backup boot config filename set.

After enabling this feature, you can specify that a backup configuration 
file not be used by entering the following command:

WX1200# clear boot backup-config
success: Backup boot config filename was cleared.

To display the name of the file specified as the backup configuration file, 
enter the display boot command. For example:

WX1200# display boot
Configured boot version:         4.1.0.60
Configured boot image: 

 wxb04102.rel

Configured boot configuration:   file:configuration
Backup boot configuration:       backup.cfg
Booted version:                  4.1.0.60
Booted image: 

 wxb04102.rel

Booted configuration:            file:configuration
Product model:                   WX

To reset the WX switch to its factory default configuration, use the 
following command:

This command removes the configuration file that the WX switch 
searches for after the software is rebooted.